• Code: 00010036
• Description: Type-B board installation error
• Causes: A Type-B board lower than level 2 is installed.
• Remedy: Remove the installed Type-B board.

• Code: 00010037
• Description: Head thermistor error
• Causes: • The head thermistor is faulty. • The temperature of the thermistor is lower than minus 20 degrees C or higher than 100 degrees C. • The Head FFC is disconnected, or its contact is poor.
• Remedy: 1. Check the connection status of the Head FFC and correct it if necessary. 2. Replace the PRINT HEAD .

• Code: 00010038
• Description: Transistor thermistor error
• Causes: • The transistor thermistor is faulty. • The temperature of the thermistor is lower than minus 20 degrees C or higher than 100 degrees C.
• Remedy: Replace the BOARD ASSY., MAIN .

• Code: 0001003E
• Description: Pressure Sensor failure
• Causes: • The Pressure Sensor is ON when an ink pressurizing operation is not performed. (disconnection of the Pressure Sensor connector, malfunction of the Pressure Sensor, or Main Board failure) • The inside pressure cannot be reduced to the same level as atmospheric pressure. (valve failure, Regulator Solenoid failure, Pressure Tube failure, or Main Board failure)
• Remedy: 1. Reconnect the Pressure Sensor connector securely. 2. Connect the Pressure Tube. 3. Replace the PUMP ASSY., SUPPLY . 4. Replace the BOARD ASSY., MAIN .

• Code: 0001003F
• Description: The Pressure Motor reached its end of life.
• Causes: The cumulative number of steps of the Pressure Motor reached the prescribed upper limit
• Remedy: Replace the PUMP ASSY., SUPPLY ., and reset the life counter of the Pressure Pump Unit using the Adjustment Program.

• Code: 00010040
• Description: Printing position error
• Causes: • Exact detection of printing positions is impossible due to dirt or scratches on the Timing Fence or the CR Encoder. • Malfunction of the program
• Remedy: 1. Replace the SCALE, CR . 2. Replace the CR Encoder Sensor . 3. Execute the CR Encoder Sensor Adjustment . 4. Installing Firmware

• Code: 00020000
• Description: NVRAM error
  The printer causes this error and stops operation when it detects that parameters stored on the NVRAM are corrupted.
• Causes: NVRAM erasing or writing error (every 2-byte is checked)
• Remedy: Replace the BOARD ASSY., MAIN .

• Code: 00020002
• Description: SDRAM error
  The printer causes this error and stops operation when it detects a bit error by the SDRAM memory check performed during the power-on sequence.
• Causes: • SDRAM reading/writing error • SDRAM failure • The address/data bus on the Main Board is broken or its contact is poor.
• Remedy: Replace the BOARD ASSY., MAIN .