• Code: 141E
• Description: Velocity deviation error
  Detects that it is being driven at an irregularly faster speed than the specified value. • Irregular load • Encoder failure • Motor driver failure • Motor failure
• Remedy: Replace the Ink System Unit. Replace the Main Board Assy.

• Code: 141F
• Description: Lock error
  Detects that it is being driven at an irregularly slower speed than the specified value. • Encoder cable is damaged. • Motor cable is damaged. • Irregular load • Encoder failure • Motor failure
• Remedy: Check the connection between the Ink System Unit and the Main Board Assy. Replace the Ink System Unit.

• Code: 1427
• Description: CSIC destination setting error
  An Ink Cartridge for a wrong destination has been installed. The Ink Holder is not adjusted correctly.
• Remedy: Replace the Ink Cartridge with a correct one for this printer. Start the printer in the Serviceman Mode without setting the ink cartridge, and then execute “Ink Holder Adjustment” from the Service Program.

• Code: 1428
• Description: Ink Holder adjustment error
  The adjustment statuses of the Ink Holder on the left and on the right are not the same. This service call error does not occur for Epson Stylus Pro 7700/7710 /9700/9710.
• Remedy: 1. While opening the cover of the Ink Holder (to avoid a service call error from occurring), start the printer in the Serviceman Mode. 2. Execute “Ink Holder Adjustment” from the Service Program.

• Code: 1430
• Description: Holder ink pad error
  The number of replacement counter of the ink cartridges has reached the specified life. (the life of the waste ink pad attached to the ink cartridge holder)
• Remedy: Check if the waste ink pads attached to the ink cartridge holder are contaminated. If it has already absorbed a considerable amount of ink, exchange the ink cartridge holder (L and R), and clear the counter using the Service Program.

• Code: 1431
• Description: Ink selector life error
  The number of operation counter of the Ink Selector has reached the specified life.
• Remedy: Replace the Ink Selector, and clear the counter using the Service Program.

• Code: 1434
• Description: IC cover unlock error
  The IC Cover can not be opened.
• Remedy: Check if the IC Cover is correctly installed. Check if the sensor which detects the open/closed status of the cover, and the solenoid which locks the cover have any defects. Replace the Cartridge Cover Sensor (L/R) with new ones.

• Code: 1438
• Description: Maintenance tank error
  A Maintenance Tank for a wrong destination has been installed.
• Remedy: Replace the Maintenance Tank with a correct one for this printer.