Description: The intake fan is located in the front, center of the drum drawer. (The drum drawer is referred to as the upper front drawer for end users.) Fan rotation stops when the drawer is opened. A fan error message appears when fan motion is NOT detected by the DC controller’s micro-processor if the drawer is closed and the printer is not in PowerSave mode
Remedy: 1. Turn the printer off and on to reset the printer. Due to the difficulty of observation, listen to hear if the fan is rotating. 2. Verify FM3 connector 27 is not damaged or broken. 3. Verify the fan connector is firmly seated into connector J1022 of the DC controller PCB. 4. If the error persists, replace the fan.
Description: Indicates there is a printer firmware problem. Either there is no firmware DIMM installed or the DIMM has failed. If the formatter was just replaced, make sure all DIMMs have been moved from the old formatter to the new one.
Remedy: 1. Turn the printer off and on to reset the printer. 2. Reseat the firmware DIMM, making sure it is in the slot surrounded by a white line with the text "ROM ONLY IN THIS SLOT".