Code :

Code: 62.00.00
Display: 62.00.00 No system To continue turn off then on
Description: The product experienced an internal system failure.
Remedy: 1. Turn the printer off, then on.2. If the error persists, reload the firmware. If the error still persists, perform a firmware upgrade.3. If the firmware upgrade does not resolve the problem, replace the hard disk.

Code: 70.00.00
Display: 70.00.00 Error To continue turn off then on
Description: DC controller failure.
Remedy: 1. Turn the printer off, and then on.2. If the error persists, replace the DC controller.ror sti

Code: 80.0X.YY
Display: 80.0X.YY Embedded Jetdirect Error
Description: An Embedded HP JetDirect print server critical error has occurred.
Remedy: 1. Turn the printer off, and then on.2. Remove the RJ45 cable.3. Turn the printer off, and then on.4. Reconnect the RJ45 cable.5. If the error persists, replace the formatter.

Code: 82.73.46
Display: 82.73.46, 82.73.47
Description: A hard disk or compact flash disk cleaning failed. This error is usually caused by a failure of the disk hardware.
Remedy: 1. Turn the product off, and then on.2. Use the Clean Disk item in the Preboot menu.3. Reload the firmware.

Code: 82.73.47
Display: 82.73.46, 82.73.47
Description: A hard disk or compact flash disk cleaning failed. This error is usually caused by a failure of the disk hardware.
Remedy: 1. Turn the product off, and then on.2. Use the Clean Disk item in the Preboot menu.3. Reload the firmware.

Code: 90.15.00
Display: 90.15.00
Description: The video interface has been detected. Communication with the Control Panel has been detected. This message is a normal part of booting up and establishing communication with the control panel.
Remedy: No action necessary.

Code: 90.15.01
Display: 90.15.01
Description: The video interface has NOT been detected. Communication with the Control Panel has not been established in the expected time frame. The control panel likely will not display properly.
Remedy: 1. Turn the printer off and then on.2. Turn the printer off by holding down the power button for at least 10 seconds.3. Ensure Control Panel Connectors at Control panel are properly seated. Power cycle device with long press of power button. If Formatter status LED is Yellow, Control Panel may be defective.4. Replace the Control Panel.

Code: 98.00.0
Display: 98.00.01 or 98.01.00 Corrupt data in firmware volume
Description: Data corrupt has occurred in the firmware volume.
Remedy: 1. Turn the printer off, and then on.2. Use the Clean Disk item in the Preboot menu.3. Reload the firmware.