Code :

Code: 79:04
Description: Generic Firmware Error (unexpected).
Remedy: Unplug the power cable from the printer and wait a few seconds. Plug in the power cable again and check if the Error Code has disappeared.
If the Error Code reappears, check for a new Firmware release.

Code: 81:01
Description: Paper-Axis shutdown - usually a paper-jam caused by a blockage of the Paper-axis System.
Remedy: If this error code was caused by a paper-jam, unplug the power cable from the printer and clear the blockage. Plug in the power cable again and check if the Error Code has disappeared
?If this error code appeared but was NOT caused by a paper jam, replace the Paper-Axis Motor Drive Assembly

Code: 81:01
Description: Paper-Axis shutdown - usually a paper-jam caused by a blockage of the Paper-axis System.
Remedy: If this error code was caused by a paper-jam, unplug the power cable from the printer and clear the blockage. Plug in the power cable again and check if the Error Code has disappeared
?If this error code appeared but was NOT caused by a paper jam, replace the Paper-Axis Motor Drive Assembly

Code: 83:01:1
Description: The paper is rejected from the Bypass due to skew.
Remedy: When manually loading paper from the front of the paper, make sure that it is loaded straight.

Code: 85:10
Description: Paper-Axis Encoder error.
Remedy: Make sure that the Encoder Sensor cable is connected correctly.
?Replace the Paper-Axis Motor Drive Assembly.
?Replace the Electronics Module

Code: 86:01
Description: Scan-axis shutdown - usually a paper-jam caused by a blockage of the Scan-axis System.
Remedy: Check that there are no obstacles in the Scan-Axis which stops the Carriage from moving freely.
Too much friction in the Slider Rod, try lubricating the Slider Rod.
The Carriage is bumping into the Service Station. If the Carriage is stuck at the right hand side of the Printer and cannot be moved out to the center of the Print Platen it is because the Service Station cannot uncap the printheads. In this case replace the Service Station Assembly
Check that the belt is correctly installed and not damaged.
Check that the Turnaround Pulley is correctly installed.
Replace the Carriage Motor Assembly

Code: 86:11
Description: Scan-axis shutdown during initialization. Typically, this error occurs when the printer detects an incorrect length.
Remedy: Unplug the power cable from the printer and wait a few seconds. Plug in the power cable again and check if the Error Code has disappeared.
Check that the Paper-Axis Drive Motor Assembly is correctly installed and that the bushing is correctly locked into position.
Check that the Carriage moves freely and DOES NOT bump into the Service Station.
If the Printheads are not installed, maybe the carriage cover is not closed completely.
If the Error Code continues, replace the Carriage Assembly

‹ First < 2 3 4 5 6 7 8 >