Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi HP DesignJet 30n — Trang 3/8

Code: 275:00

Description: Color Calibration Failure - Color Calibration cancelled.
Remedy: Clean the electrical contacts on the light magenta printhead.
If the error code continues, replace the magenta printhead.

Code: 35:01

Description: No Cleanout Assembly (or Duplexer, if installed) detected while loading media.
Remedy: Remove the Cleanout Assembly (or Duplexer, if installed) and install it again correctly. ?
Replace the Duplexer Interconnect PCA.
?If the Error Code continues, replace the Cleanout Assembly

Code: 42:10

Description: Carriage Motor failure (short-circuit).
Remedy: Replace the Carriage Motor Assembly

Code: 56:10

Description: Error during the calibration of the motor encoder system or a problem finding the zero position on the Encoder Disc.
Remedy: Replace the Paper-Axis Motor Drive Assembly Replace the Encoder Disc.

Code: 58:10

Description: Line Sensor/Carriage Failure (during Color Calibration).
Remedy: Replace the Carriage Assembly

Code: 61:05

Description: Firmware Upgrade or Color Calibration was rejected because the file was sent in the wrong format.
Remedy: Upgrade the RIP software or the Designjet System Maintenance Tool.

Code: 61:05

Description: Firmware Upgrade or Color Calibration was rejected because the file was sent in the wrong format.
Remedy: Upgrade the RIP software or the Designjet System Maintenance Tool.

Code: 64:04

Description: Firmware Error (USB Port).
Remedy: Unplug the power cable from the printer and wait a few seconds. Plug in the power cable again and check if the Error Code has disappeared.
If the Error Code reappears, check for a new Firmware release.
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie