• Code: 275:00
• Description: Color Calibration Failure - Color Calibration cancelled.
• Remedy: Clean the electrical contacts on the light magenta printhead.
  If the error code continues, replace the magenta printhead.

• Code: 35:01
• Description: No Cleanout Assembly (or Duplexer, if installed) detected while loading media.
• Remedy: Remove the Cleanout Assembly (or Duplexer, if installed) and install it again correctly. ?
  Replace the Duplexer Interconnect PCA.
  ?If the Error Code continues, replace the Cleanout Assembly

• Code: 42:10
• Description: Carriage Motor failure (short-circuit).
• Remedy: Replace the Carriage Motor Assembly

• Code: 56:10
• Description: Error during the calibration of the motor encoder system or a problem finding the zero position on the Encoder Disc.
• Remedy: Replace the Paper-Axis Motor Drive Assembly Replace the Encoder Disc.

• Code: 58:10
• Description: Line Sensor/Carriage Failure (during Color Calibration).
• Remedy: Replace the Carriage Assembly

• Code: 61:05
• Description: Firmware Upgrade or Color Calibration was rejected because the file was sent in the wrong format.
• Remedy: Upgrade the RIP software or the Designjet System Maintenance Tool.

• Code: 61:05
• Description: Firmware Upgrade or Color Calibration was rejected because the file was sent in the wrong format.
• Remedy: Upgrade the RIP software or the Designjet System Maintenance Tool.

• Code: 64:04
• Description: Firmware Error (USB Port).
• Remedy: Unplug the power cable from the printer and wait a few seconds. Plug in the power cable again and check if the Error Code has disappeared.
  If the Error Code reappears, check for a new Firmware release.