Description: A page is jammed in the indicated tray. The page did not reach the delivery sensor or registration sensor in the designated amount of time after leaving the input source. • 13.B2.D2 (event code): Misfeed jam from Tray 2 This jam occurs when the paper does not reach the registration (Registration; SR8) sensor in designated amount of time from the start of paper pick-up at printing from Tray 2 and duplex printing. • 13.A3.D3 (event code): Misfeed jam from Tray 3 This jam occurs when the paper does not reach the feed sensor of each tray in designated amount of time after the start of paper pickup.
Remedy: Clear the jam. See the clear jams section in the service manual.
Remedy: 1. Turn the product off, then on again. 2. After the product warms up, repeat the calibration process. 3. If the error persists, replace the scanner.
Remedy: 1. Turn the product off and then on. 2. Remove the formatter, and then reinstall the formatter. 3. If the error persists, replace the formatter.
Description: • 30.01.06 (event code): Scanner fan error. • 30.01.41 (event code): Internal communication error involving the copy processor board (CPB) on the formatter. • 30.01.42 (event code): Internal communication error.
Remedy: • 30.01.06 (event code) 1. Turn the product off and then on. 2. Check the fan, and reconnect any loose cables. 3. If the error persists, replace the fan or the scanner control board. • 30.01.41 (event code) 1. Turn the product off and then on. 2. Reseat the formatter. 3. If the error persists, replace the formatter. • 30.01.42 (event code) 1. Turn the product off and then on. 2. Check the cables connecting the scanner control board. 3. If this error occurs after a formatter, fax card or hard disk has been replaced, check that the formatter is fully seated and the "smiley face" is illuminated. Check the fax card for proper seating on the formatter. If it is not properly seated, it can prevent the formatter from seating properly. 4. If the error persists, replace the scanner control board.
Description: The product has detected a problem with the scanner. This error occurs when there is a CPB memory failure and the formatter needs to be replaced.
Remedy: 1. Turn power off then on. 2. If the error persists, replace the formatter.
Nhận ưu đãi sớm nhất khi chương trình diễn ra
Đăng ký nhận bản tin
Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này.
Chính sách cookie
Những cookie này là cần thiết để trang web hoạt động đúng cách.
Những cookie này giúp chúng tôi hiểu cách khách truy cập tương tác với trang web.
Những cookie này được sử dụng để cung cấp quảng cáo cá nhân hóa.