Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi HP LaserJet M3035 MFP — Trang 3/7

Code: 22

Display: 22 Embedded I/O buffer overflow To continue touch OK
Description: Too much data was sent to the embedded HP Jetdirect print server.
Remedy: Touch OK to print the transferred data. (Some data might be lost.)

Code: 22

Display: 22 USB I/O buffer overflow To continue touch OK
Description: Too much data was sent to the USB buffer.
Remedy: Touch OK to clear the error message. (Data will be lost.)

Code: 30.1.YY

Display: 30.1.YY Scanner failure
Description: An error has occurred in the scanner.
Remedy: 1. Make sure that the scanner lock is in the unlocked position. 2. Turn the device off and then on. 3. Check the cable connections between the ADF/scanner assembly and the formatter. 4. If this message persists, replace the scanner assembly. 5. If, after replacing the scanner assembly, the message persists, replace the formatter

Code: 40

Display: 40 EIO <X> bad transmission To continue touch OK
Description: The connection between the device and the EIO card in the specified slot has been broken.
Remedy: Touch OK to clear the error message and continue printing. Check the EIO connection.

Code: 40

Display: 40 Embedded I/O bad transmission To continue touch OK
Description: A temporary printing error has occurred.
Remedy: 1. Turn the device off, and then turn the device on. 2. If this message persists, replace the formatter

Code: 41.3

Display: 41.3 - Load tray <XX> To use another tray, touch OK
Description: The specified tray does not contain the specified media size.
Remedy: Touch OK to use a tray that contains media of the correct size.

Code: 41.3

Display: 41.3 - Load tray <XX>: <Type>, <Size>
Description: The specified tray is loaded with media that is longer or shorter in the feed direction than the size configured for the tray.
Remedy: Touch OK to display Tray <X> Size. Reconfigure the size in a tray so that the device will use a tray that is loaded with the size of media required for the print job. If the message does not clear automatically from the control-panel display, turn the device off, and then turn the device on.

Code: 41.X

Display: 41.X Error To continue touch OK
Description: A temporary printing error occurred. X description 2 beam detect misprint 8 fuser too hot
Remedy: 1. Touch OK to clear the error. If the error is not cleared, turn the device off, and then turn the device on. 2. If the message persists, replace the fuser
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie