Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi KIP 1900

Code: E0

Description: Fuser Error (High Temperature)
Causes: The Heater Lamp exceeds 190 degrees Centigrade.

Code: E1

Description: Fuser Error (Low Temperature)
Causes: 1. In case that the temperature of the Heater Lamp is lower than 130 degrees Centigrade when the machine is turned on. a. The Heater Lamp does not reach 130 degrees Centigrade in 8 minutes after the machine is turned on. b. The Heater Lamp does not reach 175 degrees Centigrade in 8 minutes after the Heater Lamp becomes 130 degrees Centigrade. 2. In case that the temperature of the Heater Lamp is higher than 130 degrees Centigrade when the machine is turned on. a. The Heater Lamp does not reach 155 degrees Centigrade in 8 minutes after the machine is turned on. b. The Heater Lamp does not reach 165 degrees Centigrade in 8 minutes after the Heater Lamp becomes 155 degrees Centigrade. 3. The temperature of the Heater Lamp becomes lower than 145 degrees Centigrade during the warming up. 4. The temperature of the Heater Lamp becomes lower than 120 degrees Centigrade during the Ready condition. 5. The temperature of the Heater Lamp becomes lower than 90 degrees Centigrade during the Power Saving Mode. 6. The condition of the machine does not become the Ready condition in 5 minutes after switching from the Film Mode to Plain Paper Mode or the Vellum/Tracing Mode.

Code: E2

Description: EEPROM Error
Causes: 1. Writing to the EEPROM is failed. 2. Reading the EEPROM is failed.

Code: E3

Description: Cutter Error (Time Over)
Causes: The Cutter does not stop working in 2 seconds after the Cutter starts to work.

Code: E4

Description: Cutter Error (Switch Abnormal)
Causes: The Cutter Home Position Switches (SCUT1 and SCUT 2) detect “1” while the Cutter is working.

Code: E6

Description: Pocket Door Error (Time Over)
Causes: The Pocket Door does not stop moving in 2 seconds after the Pocket Door starts to move.

Code: E7

Description: Pocket Door Error (Switch Abnormal)
Causes: Both the Open Sensing Switch and the Close Sensing Switch detect “0” while the Pocket Door is moving.

Code: E9

Description: Exposure Lamp Error (Dark)
Causes: The light intensity of the Exposure Lamp is less than the specified amount.
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie