Causes: 1. Fuser temperature does start rising up within 120 seconds since you have turned on the machine. 2. Fuser temperature becomes colder than 70 degrees centigrade since the machine has been ready.
Causes: 1. Toner Cartridge Home Position Signal (CG_HP) is still L although 30 seconds has passed since you turned on the machine. 2. Connector (J29) to the Developer Unit is disconnected. (DEVCN = “L”, when it is connected.)
Causes: 1. The Status Signal continues to be L for more than 100 milliseconds when the Counter is counting. 2. The Status Signal continues to be H for more than 100 milliseconds when the Counter is not counting
Causes: 1. Cutter is not at the home position when the Cutter Motor is not rotating. 2. It takes longer than 1.5 seconds to move the Cutter from one home position to another one.