Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi Kyocera FS3700

Code: E0

Description: Communication error
Communication between the engine controller and the main controller is failed.
Causes: • Controller gate array defect • Connector failure between the engine and the main controller • Overrun in the engine system, deactivating the progam flash ROM

Code: E1

Description: Main motor error
The main motor is overtorqued.
Causes: • Overcurrent in the main motor circuitry due to an axcessive torque • Loose connector • Defective gate array on the engine board • No response from the main motor due to the defective motor driver (transistor)

Code: E2

Description: Laser scanner motor error
The polygon motor does not deliver a synchronous output (L) within the predetermined period of time.
Causes: • Timeout in the predetermined period of lead time which the scanner motor speed has to be reached at start up (SCRDY*) • Connector insertion error • Defective gate array on the engine board • Time out dur to the defective scanner motor driver (transistor)

Code: E3

Description: Laser beam detection error
Beam detection is failed. The photo detector board does not deliver a synchronous output (L).
Causes: • No beam hit due to the laser diode defect (PD*) • Improper connector insertion • Soiled/defective beam detector (pinphoto diode) sensor • Defective safety lock • Unoperative gate array input port

Code: E4

Description: Fuser heater error
The fuser heater is not intact due to disconnection or the circuit failure.
Causes: • Blown-out thermistor • Improper connector insertion • Blown-out halogen heater • Blown-out thermostat • Comparator defect on the engine board • Defective engine CPU (input port) • Defective gate array (input/output port operation)

Code: E5

Description: Eraser error
The eraser is blown out or the power supply does not reach to the eraser
Causes: • Blown-out LED chip(s) • Connector insertion error • Defective gate array (input/output port)

Code: E6

Description: Flash ROM error
Checksum is erroneous with the flash ROM.
Causes: • Data readout error on the flash ROM

Code: E9

Description: Toner motor error
The toner motor is overtorqued
Causes: • Overcurrent in the toner motor circuitry due to an axcessive torque • Loose connector • Defective gate array on the engine board • Defective toner motor overcurrent detector
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie