Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi Kyocera TASKalfa 3051ci — Trang 29/31

Code: 9080

Description: LED fault detection
A block is existent below a peak which was obtained by activating the LEDs in the four CIS blocks at power on, which is less than 80hex.
Remedy: DP CIS: 1. Execute CIS automatic original document alignment by U411 . 2. Confirm that the wiring connector is firmly connected and, if necessary, connect the connector all the way in. CIS and DP SHD PWB (YC2) DP SHD PWB (YC1) and DP main PWB (YC10) 3. If the wiring is disconnected, shorted or grounded, replace the wiring. 4. Replace the CIS and execute U411.
DP SHD PWB: Replace the DP SHD PWB.

Code: 9100

Description: Coin vender control PWB error
Communication error has been detected at the coin mec of the coin vender control PWB.
Remedy: Coin vender control PWB: Replace the coin mec.

Code: 9110

Description: Coin vender rejector error
Communication error has been detected in connection with the coin mec and the rejector.
Remedy: Rejector: 1. Check that the rejector is firmly installed and, if not, install firmly. 2. Replace the rejector.

Code: 9120

Description: Sensor error in coin vender change (Yen 10)
Change is empty despite change is enough.
Remedy: Coin jam in the change tube: Check visually and remedy.
Contact in the connector: Check the connection of the empty change sensor.
Change empty sensor: Replace the coin mec.
Coin vender control PWB: Replace the coin mec.

Code: 9130

Description: Sensor error in coin vender change (Yen 50)
Change is empty despite change is enough.
Remedy: Coin jam in the change tube: Check visually and remedy.
Contact in the connector: Check the connection of the empty change sensor.
Change empty sensor Replace the coin mec.
Coin vender control PWB: Replace the coin mec.

Code: 9140

Description: Sensor error in coin vender change (Yen 100)
Change is empty despite change is enough.
Remedy: Coin jam in the change tube: Check visually and remedy.
Contact in the connector: Check the connection of the empty change sensor.
Change empty sensor: Replace the coin mec.
Coin vender control PWB: Replace the coin mec.

Code: 9150

Description: Sensor error in coin vender change (Yen 500)
Change is empty despite change is enough
Remedy: Change tube: Check no exchange jam is observed at the outlet and, if necessary, repair it.
Contact in the connector: Check the connection of the empty change sensor.
Change empty sensor: Replace the coin mec.
Coin vender control PWB: Replace the coin mec.

Code: 9160

Description: Coin vender pay-out error
Coin is paid out despite the pay-out motor is determined not active.
Remedy: Pay-out motor: Replace the coin mec.
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie