Description: While feeding from a lower tray, tray 3 pass thru sensor is not made. Possible causes: • Incorrect paper loading for lower tray • Incorrect media restraint setting for lower tray • Paper tray 3 assembly failure • Lower tray 4 assembly failure
Remedy: 1. Clear away anything in the paper path that might cause the media to jam. 2.Make sure proper media is set for the type of paper used in lower feeding tray. 3. Fan media, and stack flat in the lower feeding tray. 4. Properly set media restraints in the lower feeding tray. 5. Check the pick arm rolls in lower tray and replace if worn. If the problem persists, go to “243.26—Paper Jam service check”.
Description: While feeding from a lower tray, tray 3 pass thru sensor did not break. Possible cause is a paper tray 3 assembly failure
Remedy: • Clear away anything in the paper path that might cause the paper to jam. • Reseat option tray 3 • If the problem persists, go to “243.27—Paper Jam service check”.
Description: Pick timeout from tray 4 was exceeded without a tray 4 sensor break. Possible causes: • Tray 4 incorrect media setting • Tray 4 incorrect paper loading • Tray 4 incorrect media restraint setting • Tray 4 assembly failure • Aligner failure • Transport belt module failure
Remedy: 1. Remove all media present in the paper path. 2.Maker sure proper media is set for the type of paper used in tray 4. 3. Fan the media, and stack flat in tray 4. 4. Properly set media restraints in tray 4. If the problem persists, go to “244.03, 244.11— Paper Jam service check”.
Description: Tray 4 picked, but page failed to reachthe option sensor in time. Possible causes: • Tray 4 incorrect media setting • Tray 4 incorrect paper loading • Tray 4 incorrect media restraintsetting • Tray 4 paper pick mechanismassembly failure • Loading card stock from the special media tray above the fillline.
Remedy: 1. Ensure proper media is set for the type of paper used in tray 4. 2. Fan media, and stack flat in tray 4. 3. Properly set the media restraints in tray 4. 4. Check the pick arm rolls (tires) in tray 4 and replace if worn. If the problem persists, go to “244.05—Paper Jam service check”.
Description: Tray 4 page exit pass thru made early. Possible causes: • Defective pass thru sensor • Faulty cable in connector OPT1
Remedy: • Make sure proper media is set for the type of paper used in tray 4. • Check for anything in the paper path that might cause the paper to jam. • The exit pass thru sensor may not be functioning properly. Go to “244.10—Paper Jam service check”.
Nhận ưu đãi sớm nhất khi chương trình diễn ra
Đăng ký nhận bản tin
Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này.
Chính sách cookie
Những cookie này là cần thiết để trang web hoạt động đúng cách.
Những cookie này giúp chúng tôi hiểu cách khách truy cập tương tác với trang web.
Những cookie này được sử dụng để cung cấp quảng cáo cá nhân hóa.