Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi Lexmark CS510 — Trang 3/4

Code: 955.xx

Description: Service Code CRC <loc> The Code ROM or NAND flash failed the Cyclic Redundancy Check (CRC) check or the NAND experienced an uncorrectable multi-bit failure. <loc> indicates the source of the failure and has one of the following values: • CRC Failure: The source is a failing package indicated by Pn where n is the package number. This error could occur on a controller with ROM or NAND flash and could occur as a result of the CRC check done when the machine is powered on. The range of package numbers is from 0 to 15. • Error Correction Code (ECC) Failure: The source is a failing page indicated by Bn where “n” is the page number. This error occurs only if a multi-bit failure is detected during the ECC execution. Single bit failures will be corrected automatically and will not result in a service error. The range of page numbers is from 0 to 1023.
Remedy: • POR the printer. • If the problem persists, then replace the controller board.

Code: 956.xx

Description: Service Controller Board Controller board failure. Processor failure. Check on .02 for fan error.
Remedy: • POR the printer. • If the problem persists, then replace the controller board.

Code: 957.xx

Description: Service Controller Board Controller board failure. ASIC failure.
Remedy: • POR the printer. • If the problem persists, then replace the controller board.

Code: 958.xx

Description: Service NAND Failure Printer has performed more than 100 “shift and reflash” operations as a result of ECC bit corrections.
Remedy: • POR the printer. • If the problem persists, then replace the controller board.

Code: 959.xx

Description: Service Invalid Firmware Controller verification failure of system boot code. 959.0x Service System Board System hardware failure.
Remedy: • Update the firmware. • POR the printer. • If the problem persists, then replace the controller board

Code: 960.xx

Description: Service Memory Error RAM memory error: RAM soldered on the board is bad.
Remedy: • POR the printer. • If the problem persists, then replace the controller board.

Code: 961.xx

Description: Service Memory Failure RAM memory error: slot 1 RAM is bad.
Remedy: • Check RAM in slot 1. • If RAM is ok, then POR the printer. • If the problem persists, then replace the controller board.

Code: 962.xx

Description: Service Memory Failure RAM memory error: slot 2 RAM is bad.
Remedy: • Check RAM in slot 2. • If RAM is ok, then POR the printer. • If the problem persists, then replace the controller board.
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie