• Code: 949
• Description: Delay Line Calibration Failure
  Indicates a delay line calibration failure.
• Remedy: Replace the engine board.

• Code: 953
• Description: NVRAM FailureI
  ndicates the NVRAM chip on the engine board has failed.
• Remedy: Replace the engine board.

• Code: 954
• Description: NVRAM FailureI
  ndicates the NVRAM experienced a CRC failure.
• Remedy: Replace the engine board.

• Code: 956
• Description: Configuration ID
  Indicates a problem with the Configuration ID.
• Remedy: This error occurs because the engine received a configuration ID from the controller software which is not valid for the level of engine code existing in the printer. Setting the configuration ID correctly should fix this error. The ID can be set via the NPA data stream or operator panel. Note: This error is not generated at POR to allow the servicer a method of resetting the configuration ID. However, setting the configuration ID is the only operation that the servicer can perform.

• Code: 960
• Description: RAM Memory Error
  Indicates a DRAM Memory Error on the controller board.
• Remedy: Replace the controller board.

• Code: 961
• Description: RAM in Slot 1 is Bad.
• Remedy: Replace the DIMM in Slot 1. If this does not fix the problem, replace the controller board.

• Code: 962
• Description: RAM in Slot 2 is Bad.
• Remedy: Replace the DIMM in Slot 2. If this does not fix the problem, replace the controller board.

• Code: 963
• Description: RAM in slot 3 is Bad.
• Remedy: Replace the DIMM in slot 3. If this does not fix the problem, replace the controller board.