Mã lỗi Lexmark W840 — Trang 5/9
Code:
Tất cả lỗi (70)
900.XX
903.00
904.00
905.00
906.00
907.00
908.00
910.00
911.00
912.00
913.00
914.00
915.00
916.00
918.00
919.00
919.01
920.00
921.00
922.00
923.00
924.00
925.00
927.00
928.00
929.00
930.00
932.00
933.00
939.00
941.00
942.00
943.00
944.00
945.00
945.01
951.XX
953.XX
955.XX
956.01
956.02
980.00
980.01
980.02
980.03
980.04
981.00
981.01
981.02
982.00
982.01
983.00
983.01
984.00
984.01
985.00
985.01
986.00
986.01
987.00
987.01
988.00
988.01
989.00
990.00
990.01
995.00
996.00
997.00
999.00
Display: 943.00 Service tray 3 failure
Description: Media tray 3 lift up / no tray failure
Causes: The 2TM-tray 3 sensor (media level) is not turned on within the specified time after the 2TM-tray 3 media feed lift motor is turned on. The 2TM-tray 3 switch (media size) detected no tray.
Display: 944.00 Service tray 4 failure
Description: Media tray 4 lift up / no tray failure
Causes: The 2TM-tray 4 sensor (media level) is not turned on within the specified time after the 2TM-tray 4 media feed lift motor is turned on. The 2TM-tray 4 switch (media size) detected no tray.
Display: 945.00 Service tray 5 failure
Description: Media tray 5 lift up / no tray failure
Causes: The sensor (HCF media level) is not turned on with the specified time after the HCF feed lift motor is turned on.
Display: 945.01 Service tray 5 failure
Description: Tray 5 HCF NVM R/W failure
Causes: A read/write error has occurred on the NVM of the tray 5 HCF controller card assembly.
Display: 951.XX Service NVRAM failure
Description: RIP card assembly NVRAM failure
Causes: A failure has occurred in the RIP card asm NVRAM.
Display: 953.XX Service NVRAM failure
Description: Operator panel assembly NVRAM failure
Causes: NVRAM chip failure with operator panel assembly (mirror).
Display: 955.XX Service Code CRC
Description: RIP card assembly NAND CRC failure
Causes: The code ROM or NAND flash failed the cyclic redundancy check.
Display: 956.01 Service system board
Description: RIP card assembly processor over temperature failure
Causes: The RIP card assembly has exceeded safe operating temperature.