• Code: 985.01
• Display: 985.01 Service finisher error
• Description: Sensor (punch carriage shift HP) off failure
• Causes: The sensor (punch carriage shift HP) is not turned off even when the specified time passed after the punch carriage shift motor assembly is turned on. Or the sensor (punch carriage shift HP) is turned on again after the sensor (punch carriage shift HP) is turned off and the punch carriage shift motor assembly stopped its rotation.

• Code: 986.00
• Display: 986.00 Service finisher error
• Description: Sensor (eject clamp HP) on failure
• Causes: The sensor (eject clamp HP) is not turned on within 500 ms after the eject clamp up starts.

• Code: 986.01
• Display: 986.01 Service finisher error
• Description: Sensor (eject clamp HP) off failure
• Causes: The sensor (eject clamp HP) is not turned off within 200 ms after the eject clamp down starts.

• Code: 987.00
• Display: 987.00 Service finisher error
• Description: Sensor (media eject shaft HP) on failure
• Causes: The sensor (media eject shaft HP) is not turned on within 200 ms after the set clamp starts operating.

• Code: 987.01
• Display: 987.01 Service finisher error
• Description: Sensor (media eject shaft HP) off failure
• Causes: The sensor (media eject shaft HP) is not turned off within the specified time after the set clamp ends operating.

• Code: 988.00
• Display: 988.00 Service finisher error
• Description: Sensor (punch unit side reg 1) on failure Sensor (punch unit side reg 2) on failure
• Causes: The sensor (punch unit side reg 1) or sensor (punch unit side reg 2) did not detect the media correctly or is defective.

• Code: 988.01
• Display: 988.01 Service finisher error
• Description: Sensor (punch unit side reg 1) off failure Sensor (punch unit side reg 2) off failure
• Causes: The sensor (punch unit side reg 1) or sensor (punch unit side reg 2) did not detect the media correctly or is defective.

• Code: 989.00
• Display: 989.00 Service finisher error
• Description: Stapler unit failure
• Causes: The off/on status of the sensor (stapler unit motor HP) is not detected within the specified time after the stapler unit motor (forward operation). Or the sensor (stapler unit motor HP) is not turned on within the specified timer after the stapler unit motor is on (reverse operation).