• Code: 932
• Description: Printhead—lost hsyncs
• Remedy: Replace the printhead.

• Code: 934
• Description: Printhead—mirror motor lost lock
• Remedy: Replace the printhead.

• Code: 935
• Description: Printhead—mirror motor unable to reach operating speed.
• Remedy: Faulty printhead, cabling, or connector.

• Code: 936
• Description: Transport motor — initial lock failure
• Remedy: Indicates a problem with the main drive motor or a jam occurred during the motor ramp-up to speed.

• Code: 937
• Description: Transport motor — lost lock
• Remedy: Faulty motor or a jam occurred after motor ramp-up to speed. Possible problem with the main drive.

• Code: 941
• Description: Scanner — AFE R/W Error for scanner
• Remedy: Replace the controller card.

• Code: 942
• Description: Scanner — Home sensor error
• Remedy: CCD Controller card If you are receiving a 942 error, check the home position sensor for dirt, and ensure that the sensor is properly connected to the CCD. Ensure that connectors J1 and J4 are properly connected. Inspect both ribbon cable connections on CCD for proper connection. If connector J1 is properly connected, verify the following voltages on the controller card. Check pin 1 for +5V, pin 5 for +24V, and pin 18 for +24V. Pins 2, 4, 6, 13, 16, and 17 are ground. If connector J4 is properly connected, verify the following voltages on the controller card. Check pin 19 for +12V and pin 20 for +5V. If voltages are present, replace the CCD. If there are voltage irregularities, replace the controller card.

• Code: 943
• Description: Scanner — Motor stall
• Remedy: Restart the MFP. If the problem remains, replace the CCD unit.