Code :

Code: 944
Description: Scanner — Lamp error
Remedy: Restart the MFP. Verify that the lamp is not illuminating during the startup.
CCD Controller card If you are receiving a 942 error, check the home position sensor for dirt, and ensure that the sensor is properly connected to the CCD. Ensure that connectors J1 and J4 are properly connected. Inspect both ribbon cable connections on CCD for proper connection. If connector J1 is properly connected, verify the following voltages on the controller card. Check pin 1 for +5V, pin 5 for +24V, and pin 18 for +24V. Pins 2, 4, 6, 13, 16, and 17 are ground. If connector J4 is properly connected, verify the following voltages on the controller card. Check pin 19 for +12V and pin 20 for +5V. If voltages are present, replace the CCD. If there are voltage irregularities, replace the controller card.

Code: 948
Description: Fax Storage
Remedy: There is an unrecoverable problem with the flash file system used for fax storage.

Code: 960
Description: RAM soldered on the card is bad
Remedy: Indicates a DRAM Memory Error on the controller card. Replace the controller card.