Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi Mimaki JV4-160 — Trang 3/4

Code: 34

Display: ERROR34 DATA REMAIN
Description: • Operating condition is tried to be changed when data that has not yet been plotted remains.
Remedy: 1) This tells that any of the operating conditions cannot be changed if data that have not been plotted remains.

Code: 40

Display: ERROR40 MOTOR X
Description: • The X-axis motor has been overloaded.
Remedy: 1) Replace X axis motor. 2) Replace a main PCB.

Code: 41

Display: ERROR41 MOTOR Y
Description: • The Y-axis motor has been overloaded. • The brush of motor is in abnormal conditions.
Remedy: 1) Clean the main guide axis. 2) Replace Y axis motor. 3) Replace a main PCB.

Code: 42

Display: ERROR42 X CURRENT
Description: • Overcurrent error has arisen on the X-axis motor
Remedy: 1) Replace X axis motor. 2) Replace a main PCB.

Code: 43

Display: ERROR43 Y CURRENT
Description: • Overcurrent error has arisen on the Y-axis motor
Remedy: 1) Replace Y axis motor. 2) Replace a main PCB.

Code: 45

Display: ERROR45 CAPPING
Description: • The capping-control is in abnormal conditions.
Remedy: 1) Turn on the power. 2) Replace a slider PCB. 3) Replace a cap sensor. 4) Replace a IO PCB. 5) Replace a station sensor. 6) Replace a station motor.

Code: 46

Display: ERROR46 WIPER
Description: • The wiper-control is in abnormal conditions
Remedy: 1) Turn on the power. 2) Replace a wiper assy. 3) Replace IO PCB. 4) Replace a wiper sensor. 5) Replace a wiper motor.

Code: 50

Display: ERROR50 MEDIA SENSE
Description: • Media detection has not been successfully carried out.
Remedy: 1) Make sure that there is no gap between platen F (aluminum) and the edge of the P cover F rubber. If there is a gap, stick the rubber appressed against the platen. The gap may be detected in mistake. 2) Make sure that platen cover F is fixed securely using the platen cover F mounting screws (attached on auxiliary side plates R and L to prevent the cover from protruding). 3) Check if the media right edge is set at a position 15mm or more from the rightmost edge of the rightmost feed roller:R1 toward the station side or not. 4) Cleaning or replace a paper width sensor. 5) Replace a main FPC cable. 6) Replace a slider PCB. 7) Replace a HDC-4Head PCB. 8) Replace a main PCB.
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie