Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi OKI B721dn — Trang 4/8

Code: 134

Description: LED head fault detected. (134=K)
Remedy: Is LED head properly set? Does error reoccur?
Set properly for LED head unit. Turn power ON agein. Replace LED head unit

Code: 155

Description: Fuser unit fuse cannot be disconnected.
Remedy: Is fuser unit set properly? Does error reoccur?
After cleaning for fuser connector, reset. Turn power ON again. Replace the PU/ CU board.

Code: 163

Description: Error detected by toner sensor. (163=K) This error does not occur with the factory default settings.
Remedy: Is toner cartridge setting? Is toner lock lever setting? Does error reoccur?
Set toner cartridge. Turn a lock lever of toner to a fixed position. Replace toner sensor or assembly.

Code: 166

Description: An abnormality was detected with the power supply temperature thermistor. 01: Short 02: Open 03: High temp. 04: Low temp.
Remedy: 01, 02: Does error reoccur? Does error reoccur? Does error reoccur? 03: Does error reoccur? Does error reoccur? Does error reoccur? 04: Does error reoccur? Does error reoccur? Does error reoccur?
Power Off/On. Replace the low voltage power supply unit. Replace the PU/ CU board. Replace the cable between the low voltage power supply unit and the PU/CU board. Remove anything obstructing the ventilation slots if any and restore the power. Replace the low voltage power supply unit. Replace the PU/ CU board. Replace the cable between the low voltage power supply unit and the PU/CU board. Raise the room temperature and restore the power. Replace the low voltage power supply unit. Replace the PU/ CU board. Replace the cable between the low voltage power supply unit and the PU/CU board.

Code: 167

Description: ThermistorSlope Error
Remedy: Is the error message displayed? Does error reoccur?
Power Off/On. After leaving the printer for 30 minutes, turn on the printer again.

Code: 168

Description: Compensation Thermistor Error
01: Short 02: Open 03: High temp. 04: Low temp.
Remedy: Is the error message displayed? Does error reoccur?
Power Off/On. After leaving the printer for 30 minutes, turn on the printer again.

Code: 169

Description: Upper Side Thermistor Error 01: Short 02: Open 03: High temp. 04: Low temp.
Remedy: Is the error message displayed? Does error reoccur?
Power Off/On. After leaving the printer for 30 minutes, turn on the printer again.

Code: 170, 171

Description: Short circuit in fuser thermistor or open detected.
Remedy: Does error reoccur? Yes Power Off/On. Replace the fuser unit.
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie