Danh mục sản phẩm

Code :

Code: 052
Display: Service call 052:Error(C6100)
Description: DMA Abort Error detected in Image processor.
Causes: Does error reoccur?

Code: 070
Display: Power off/on 070:Error(C6100)
Description: PSE firmware fault detected.
Causes: Does error reoccur?

Code: 072
Display: Power off/on 072:Error xx
Description: Engine I/F Error I/F error between PU-CU.
Causes: Is CU assembly set properly? Is error recovered by replacing SP1 /TBH board?

Code: 073
Display: Power off/on 073:Error xxxxxxxx
Description: Video Error. A trouble was detected during image data development. (Illegal data received)
Causes: [On the C5500/C5800] Is the CU Assy installed properly? Is the error issued again?
[On the C6100] Is the CU Assy installed properly?
[Common]

Code: 074
Display: Power off/on 074:Error xxxxxxxx 075:Error xxxxxxxx
Description: Video Error Fault detected when image data is extended.
Causes: Is CU assembly set properly?

Code: 081
Display: Service call 081: ERROR
Description: Parameterconsistency check error
Causes: EEPROM or FLASH has become incapable of reading or writing.

Code: 104
Display: Service call 104:Error
Description: Engine EEPROM setting check is OK when power ON. Then detect read/ write error.
Causes: Does error reoccur?

Code: 105
Display: Service call 105:Error
Description: An error detected by checking, at printer's power-om, EEPROM installation.
Causes: Does error reoccur?

< 1 2 3 4 5 6 > Last ›

0