Danh mục sản phẩm

Code :

Code: 080
Display: Power OFF/ON
080 : Error
Description: Parameter I/O Error
An access error occurred in a storage point of a parameter by file damage.
Remedy:

Code: 081
Display: Inspection is required.
081 : Error
Description: Parameter matching check error
Reading from or writing into EEPROM or flash memory cannot be made properly.
Remedy: Turn off and on the MFP. Replace the CU/PU board when the symptom persists.

Code: 085
Display: Inspection is required.
085 : Error
Description: SD Card ECC Error
An ECC error was detected by read processing of a SD memory card.
Remedy:

Code: 104
Display: Inspection is required.
104 : Error
Description: An engine EEPROM read/write error was detected.
Remedy: Does the error occur again? Yes Turn off and on the MFP Replace the CU/PU board.

Code: 106
Display: Inspection is required.
106 : Error
Description: Engine control logic error
Remedy: Does the error occur again? Yes Turn off and on the MFP Replace the CU/PU board.

Code: 112
Display: Inspection is required.
112 : Error
Description: The 2nd tray for a model different from the MFP was detected.
Remedy: Is the 2nd tray for the MFP installed? No Install proper 2nd tray.

Code: 121
Display: Inspection is required.
121 : Error
Description: High-voltage power supply interface error
Remedy: Is the cable between the CU/ PU board and the highvoltage power unit connected properly? Is a contact faulty?
Reconnect it properly. Check the highvoltage line for no poor connection. Replace the highvoltage power supply.

Code: 122
Display: Inspection is required.
122 : Error
Description: Rear-fan error
Remedy: Does the fan at the rear of the MFP operate? Is the connector of the fan connected properly?
Be sure of the connection of the fan. Replace the CU/PU board. Connect the fan properly. Replace the CU/PU board.

< 1 2 3 4 5 6 > Last ›

0