Danh mục sản phẩm

Code :

Code: 074, 075
Display: Power OFF/ON 074 : Error 075 : Error
Description: Video error. An error was detected in expanding image data.
Remedy: Is the CU/PU installed properly?
Reinstall it properly. Replace it.

Code: 081
Display: Inspection is required. 081 : Error
Description: Parameter matching check error
Reading from or writing into EEPROM or flash memory cannot be made properly.
Remedy: Reading from or writing into EEPROM or flash memory cannot be made properly. Turn off and on the MFP. Replace the CU/PU board when the symptom persists.

Code: 104
Display: Inspection is required. 104 : Error
Description: An engine EEPROM read/write error was detected.
Remedy: Does the error occur again? Yes Turn off and on the MFP Replace the CU/PU board.

Code: 106
Display: Inspection is required. 106 : Error
Description: Engine control logic error
Remedy: Does the error occur again? Yes Turn off and on the MFP Replace the CU/PU board.

Code: 112
Display: Inspection is required. 112 : Error
Description: The 2nd tray for a model different from the MFP was detected.
Remedy: Is the 2nd tray for the MFP installed? No Install proper 2nd tray.

Code: 121
Display: Inspection is required. 121 : Error
Description: High-voltage power supply interface error
Remedy: Is the cable between the CU/ PU board and the highvoltage power unit connected properly? Is a contact faulty?
Reconnect it properly. Check the highvoltage line for no poor connection. Replace the highvoltage power supply.

Code: 122
Display: Inspection is required. 122 : Error
Description: Rear-fan error
Remedy: Does the fan at the rear of the MFP operate? Is the connector of the fan connected properly?
Be sure of the connection of the fan. Replace the CU/PU board. Connect the fan properly. Replace the CU/PU board.

Code: 123
Display: Inspection is required. 123 : Error
Description: Ambient humidity error or non connection of humidity sensor
Remedy: Is the cable from the CU/PU board to the toner sensor board connected properly?
Re-connect it properly. Replace the toner sensor board.

< 1 2 3 4 5 6 > Last ›

0