Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi OKI MC560 — Trang 7/9

Code: 181, 182

Display: Service call 181:Error 182:Error
Description: Option unit I/F error. 181 = Duplex Unit 182 = Option Tray)
Remedy: Does error reoccur? Yes Turn power ON again. After checking connection parts of connector, replace option unit.

Code: 190

Display: Power off/on 190:Error
Description: System Memory Overflow.
Remedy: Does error reoccur? Yes Turn power ON again. Add option RAM DIMM.

Code: 200 ... 202

Display: Service call 200 ~ 202 Error
Description: PU Firmware download Error.
Error occurred while writing over the PU firmware.
Remedy: Error occurered while writing over the PU firmware. Turn the printer OFF/ON, and retry to download the PU firmware again. (Usually, the procedure (PU firmware download) which isn’t done, so this is not occur.)

Code: 203 ... 214

Display: Power off/on Error codes 203,204, 207, 208, 214, FOC, FFF F0D: Error(C5900) FFE: Error(C5900)
Description: An error was detected of the CU program.
Remedy: Reinstall the CU board. Is the error message displayed again? After turn power OFF, check connections between CU board and PU board. Then turn power ON again.

Code: 209

Display: Power off/on 209:Download Error
Description: Media Table download Error.
Downloading Media Table to PU has failure.(Related to Custom Media Type)
Remedy: Downloading Media Table to PU has failure.(Related to Custom Media Type) Turn the printer OFF/ON, and retry to download the PU firmware, again. (Usually, the procedure isn’t done, so this is not occur.)

Code: 220

Display: Service call 220:Error
Description: False setting of a record medium detected by a print statistics.
Remedy: Take off the HDD or replaced? Yes Reset original HDD.

Code: 230

Display: Service call 230:Error
Description: RFID Reader not Installed
Remedy: RFID read device error Is the error issued again?
Check the connection of the RFID R/W board. Replace the RFID R/W board. Replace the S2V PCB.

Code: 231

Display: Service call 231:Error
Description: RFID Reader I/F Error
An interface error was detected with the RFID reader device. 01: communication error between the RFID reader and the engine PCB. 02: the transceiver circuit error of the RFID reader. 03: communication error between the RFID reader and the toner cartridge. 04: the toner cartridge detection error (more than 4).
Remedy: 01: Same as Error 230 02: Replace RFID R/W board. 03: Check the antenna cable connection. 04: Check to see if the quantity of toner cartridge is correct.
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie