Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi Ricoh Aficio 1075 — Trang 19/25

Code: 782

Description: Z-Fold upper stopper motor
The upper stopper was not detected at the home position after the motor remained on long enough to move it 128.7 mm.
Causes: • Upper stopper motor disconnected, defective
• Upper stopper motor overloaded due to obstruction
• Upper stopper HP sensor disconnected, defective

Code: 784

Description: Z-fold timing unit fold timing sensor adjustment error
The A/D (Digital/Analog) input value did not change even after the D/A (Digital/Analog) output value changed.
Causes: • Fold timing sensor connector loose, broken, defective
• Fold timing sensor defective
• Fold timing sensor, mylar covered with paper dust
• Mylar disconnected

Code: 785

Description: Z-fold leading edge sensor adjustment error
The A/D input value did not change even after the D/A output value changed
Causes: • Leading edge sensor connector loose, broken, defective
• Leading edge sensor defective
• Leading edge sensor, mylar covered with paper dust
• Mylar disconnected

Code: 786

Description: Z-fold EEPROM error
The write operation to the Z-folding EEPROM failed after 2 attempts
Causes: • EEPROM defective

Code: 790

Description: Finisher staple trimming hopper full
The staple waste hopper is full of cut staples
Causes: • If the hopper is full, empty the hopper
• If the hopper is not full, the hopper full sensor is disconnected, defective

Code: 817

Description: Monitor Error
This is a file detection and electronic file signature check error when the boot loader attempts to read the selfdiagnostic module, system kernel, or root system files from the OS Flash ROM, or the items on the SD card in the controller slot are false or corrupted.
Causes: • OS Flash ROM data defective; change the controller firmware
• SD card data defective; use another SD card

Code: 818

Description: Watchdog error
While the system program is running, a bus hold or interrupt program goes into an endless loop, preventing any other programs from executing.
Causes: • System program defective; switch off/on, or change the controller firmware if the problem cannot be solved
• Controller board defective
• Controller option malfunction

Code: 819

Description: Fatal kernel error
Due to a control error, a RAM overflow occurred during system processing. One of the following messages was displayed on the operation panel.
Causes: • System program defective
• Controller board defective
• Optional board defective
• Replace controller firmware
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie