Description: ID sensor error 3
For 2 s during the ID sensor pattern check, the ID sensor pattern edge voltage is not 2.5V or the pattern edge is not detected within 800 ms.
Causes: • ID sensor defective
• ID sensor harness disconnected
• ID sensor connector defective
• IOB defective
• ID sensor pattern not written correctly
• Incorrect image density
• Charge power pack defective
• ID sensor dirty
Description: ID sensor error 4
One of the following ID sensor output voltages is detected at ID sensor initialization. . Vsg < 4.0V when the maximum PWM input (255) is applied to the ID sensor. . Vsg . 4.0V when the minimum PWM input (0) is applied to the ID sensor.
Causes: • ID sensor defective
• ID sensor harness disconnected
• ID sensor connector defective
• IOB defective
• ID sensor pattern not written correctly
• Incorrect image density
• Charge power pack defective
• ID sensor dirty
Description: ID sensor error 5
Vsg falls out of the adjustment target (4.0 ± 0.2V) during Vsg checking
Causes: • ID sensor defective
• ID sensor harness disconnected
• ID sensor connector defective
• IOB defective
• ID sensor pattern not written correctly
• Incorrect image density
• Charge power pack defective
• ID sensor dirty
Description: Transfer output abnormal release detection
When the transfer is output, there is hardly any feedback voltage within 60 ms even with application of 24% PWM.
Causes: • Transfer power pack defective
• Transfer unit harness disconnected
• Transfer connector loose, defective
Description: Quenching lamp error
At the completion of auto process control initialization, the potential of the drum surface detected by the potential sensor is more than –400V, the prescribed value.