Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi Ricoh Aficio 2013 — Trang 3/10

Code: 402

Description: Transfer roller leak error 2
A current leak signal for the transfer roller is detected. A current feedback signal for the transfer roller is not detected.
Causes: • High voltage supply board defective • Poor connection of the PCU • Transfer/separation unit set incorrectly • Transfer roller damaged

Code: 500

Description: Main motor lock
A main motor lock signal is not detected for more than 7 consecutive checks (700 ms) after the main motor starts to rotate, or the lock signal is not detected for more than 7 consecutive checks during rotation after the last signal.
Causes: • Too much load on the drive mechanism • Main motor defective

Code: 541

Description: Fusing thermistor open (center)
The fusing temperature detected by the thermistor is below 71°C and is not corrected after the main power switch is turned on.
Causes: • Fusing thermistor defective or out of position • Power supply board defective • Loose connectors

Code: 542

Description: Fusing temperature warm-up error (center)
The fusing temperature rises less than 7 degrees in 2 seconds, and this continues 5 times consecutively. The fusing temperature is not detected in 25 or 35 seconds.
Causes: • Fusing thermistor defective or out of position • Fusing lamp open • Power supply board defective

Code: 543

Description: Fusing overheat error (center)
The fusing temperature is over 230°C for 1 second (detected by the thermistor).
Causes: • Fusing thermistor defective • Power supply board defective

Code: 544

Description: Fusing overheat error (center) 2
The fusing temperature is over 250°C for 1 second (detected by the fusing temperature monitor circuit).
Causes: • Fusing thermistor defective • Power supply board defective

Code: 545

Description: Fusing lamp overheat error (center)
After the fusing temperature reaches the target temperature, the fusing lamp does not turn off for 12 consecutive seconds.
Causes: • Fusing thermistor defective or out of position • Power supply board defective

Code: 546

Description: Unstable fusing temperature (center)
The fusing temperature varies 50°C or more within 1 second, and this occurs 2 consecutive times.
Causes: • Thermistor defective or out of position • Power supply unit defective
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie