Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi Ricoh Aficio 2045eG

Code: 101

Description: Exposure lamp error
• The standard white level was not detected properly when scanning the white plate.
Causes: • Exposure lamp defective • Lamp stabilizer defective • Exposure lamp connector defective • Standard white plate dirty • Scanner mirror or scanner lens out of position or dirty • SBU defective

Code: 120

Description: Scanner home position error 1
• The scanner home position sensor does not detect the on condition during initialization or copying.
Causes: • SIB or scanner drive motor defective • Scanner motor defective • Harness between SIB and scanner drive motor disconnected • Harness between SIB and scanner drive motor power source disconnected • Scanner HP sensor defective • Harness between SIB and HP sensor disconnected • Scanner wire, timing belt, pulley, or carriage defective

Code: 121

Description: Scanner home position error 2
• The scanner home position sensor does not detect the off condition during initialization or copying.
Causes: • SIB or scanner motor drive board defective • Scanner motor defective • Harness between SIB and scanner drive motor disconnected • Harness between SIB and scanner drive motor power source disconnected • Scanner HP sensor defective • Harness between SIB and scanner HP sensor disconnected • Scanner wire, timing belt, pulley, or carriage defective

Code: 130

Description: SBU defective
• Within 1 second after power on, the SOUT signal does not go high, or within 1 second after power on the SOUT signal goes high, but the SBU ID could not be read after two attempts.
Causes: • SBU defective • BICU defective • Harness between SBU and BICU disconnected or damaged

Code: 131

Description: F-Gate asserts during shading
• F-Gate was asserted by the DF during shading.
Causes: • While scanning at the DF, a software setting procedure caused an error. You must reboot the machine.

Code: 302

Description: Charge roller current leak
A charge roller current leak signal was detected.
Causes: • Charge roller damaged • High voltage supply board defective • PCU harness defective or disconnected

Code: 304

Description: Charge roller current correction error
• The charge roller bias correction is performed twice even if the maximum charge roller bias (-2000V) is applied to the roller.
Causes: • ID sensor defective

Code: 320

Description: Polygon motor error
• The polygon motor does not reach its operating speed within 25 seconds after the polygon motor on signal, or the lock signal is still activated for more than 2 seconds after the polygon motor off signal.
Causes: • Cable at the polygon mirror motor disconnected or defective • Polygon motor or polygon motor driver defective • Polygon motor drive pulse not output correctly • LOCK signal could not be detected
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie