Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi Ricoh Aficio 3045G — Trang 4/18

Code: 391

Description: TD sensor error: Auto adjust error
During automatic adjustment of the TD sensor, output voltage is less than 1.8V or more than 4.8V during TD sensor initial setting.
Causes: • TD sensor abnormal • TD sensor disconnected • Poor TD sensor connection • I/O board (IOB) defective • Toner supply defective

Code: 395

Description: Development output abnormal
A development bias leak signal is detected. High voltage output to the development unit exceeded the upper limit (65%) for 60 ms.
Causes: • High voltage supply board defective • Poor connection at the development bias terminal • Poor connection at the high voltage supply board

Code: 401

Description: Transfer roller leak detected
A transfer roller current leak signal is detected.
Causes: • High voltage supply board defective • Poor cable connection or defective cable • Transfer connector defective

Code: 402

Description: Transfer roller open error
The transfer roller current feedback signal is not detected.
Causes: • High voltage supply board defective • Transfer connector cable defective • Transfer connector defective • Poor PCU connection

Code: 403

Description: Transfer belt position sensor error
The transfer belt position sensor does not activate even if the transfer belt contact clutch has been switched on twice and rotated once.
Causes: • Main motor/drive malfunction • Transfer belt contact clutch defective • Transfer belt position sensor defective • Harness disconnected

Code: 405

Description: Transfer belt error
The transfer belt does not move away from the drum during ID sensor pattern checking.
Causes: • Main motor/drive malfunction • Transfer belt position sensor defective • Poor transfer belt position sensor connection • Transfer belt contact clutch defective

Code: 440

Description: Main motor lock
A main motor lock signal is not detected within 2 seconds after the main motor turns on.
Causes: • Too much load on the drive mechanism • Main motor defective

Code: 450

Description: Feed Development Motor Error
The PLL lock signal remains LOW for 2 s while the feed development motor is operating.
Causes: • Motor lock caused by overload. • Motor driver defective.
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie