Description: Fusing overheat error 2
The fusing lamp stays on at full power for 30 seconds while in the stand-by condition after warming-up is completed.
Description: Fusing ready temperature malfunction
The fusing temperature goes 20 °C below or 20 °C over the stand-by temperature after warm-up is completed.
Description: Zero cross signal malfunction
Zero cross signals are not detected within a certain period within 500 ms after the main power switch has been turned on.
Causes: • Power supply board defective • Noise on the ac power line
Description: 1-bin tray motor lock (optional 1-bin tray unit)
A 1-bin tray motor lock signal is not detected for more than 0.3 seconds during rotation.
Causes: • 1-bin tray motor defective • Too much load on the drive mechanism • Poor motor connector connection