Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi Ricoh Aficio 551P

Code: SC101

Description: Exposure lamp error
The standard white level was not detected properly when scanning the white plate.
Causes: • Exposure lamp defective • Lamp regulator defective • Exposure lamp connector defective • Dirty standard white plate • Dirty scanner mirror or scanner mirror out of position • SBU board defective • SBU connector defective • Lens block out of position

Code: SC120

Description: Scanner home position error 1
The scanner home position sensor does not detect the on condition during initialization or copying.
Causes: • Scanner home position sensor defective • Scanner motor defective • Scanner motor drive board defective • Scanner home position sensor connector defective • Scanner drive motor connector defective

Code: SC121

Description: Scanner home position error 2
The scanner home position sensor does not detect the off condition during initialization or copying.
Causes: • Scanner home position sensor defective • Scanner drive motor defective • Scanner motor drive board defective • Scanner home position sensor connector defective • Scanner drive motor connector defective

Code: SC124

Description: Scanner motor encoder signal error
No encoder signal from the scanner motor
Causes: • Scanner motor connector defective • Scanner motor defective • MCU defective • Scanner wire, timing belt, pulley out of position • PSU defective

Code: SC125

Description: Scanner motor speed error 1
The scanner stops before the scanner HP sensor is on when returning. The scanner speed when the scanner HP sensor turns on is slower than the specified speed.
Causes: • Scanner motor defective • MCU defective • Too much load on scanner drive

Code: SC126

Description: Scanner motor speed error 2
The scanner overruns the scanner HP sensor by more than 10 mm when returning.
Causes: • Scanner motor defective • MCU defective • Too small load on scanner drive

Code: SC127

Description: Scanner motor encoder rotating direction error
The scanner moves in the opposite direction from the instructed direction when initializing.
Causes: • Scanner motor defective • MCU defective

Code: SC128

Description: Scanner motor start error
The scanner motor speed does not reach the target speed until starting to read the original.
Causes: • Scanner motor defective • MCU defective • PSU defective • Too much load on scanner drive
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie