Description: ID sensor pattern error (K) The slope gM of the line representing the relationship between the DTM bias and attached toner amount is not between –0.01 and – 0.001.
Causes: Incorrect DTM installation, incorrect PCU installation, development bias error, MCU, LD control malfunction, loss of synchronization
Description: Low pressure roller temperature Reheating has been done and the motor is not running, or 60 seconds have passed after the main motor halted. Then, the roller temperature has been below 130ºC for 60 seconds
Description: Low hot roller temperature Reheat has been done and the motor is not running, or 60 seconds have passed after main motor halt. Then, the roller temperature has been below 130ºC for 60 seconds
Causes: Hot roller thermistor, MCU, hot roller lamp connector
Nhận ưu đãi sớm nhất khi chương trình diễn ra
Đăng ký nhận bản tin
Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này.
Chính sách cookie
Những cookie này là cần thiết để trang web hoạt động đúng cách.
Những cookie này giúp chúng tôi hiểu cách khách truy cập tương tác với trang web.
Những cookie này được sử dụng để cung cấp quảng cáo cá nhân hóa.