Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi Ricoh Aficio AP2600 — Trang 2/6

Code: 542

Description: Fusing temperature warm-up error The fusing temperature does not reach more than 80 °C 17.5 seconds after the main switch is turned on.
Causes: • Thermistor defective • Fusing lamp open • Fusing thermostat open • Power supply board defective • Poor connection of the fusing unit

Code: 543

Description: Fusing overheat error A fusing temperature of over 245 °C is detected for 1 second by the fusing thermistor. A fusing temperature of over 235 °C is detected for 1 second after the fusing lamp has been turned off.
Causes: • Fusing thermistor defective • Power supply board defective

Code: 545

Description: Fusing lamp stays on The fusing lamp stays on more than 12 seconds after the main motor has been turned off.
Causes: • Fusing thermistor defective • Power supply board defective • Poor connection of the fusing unit

Code: 546

Description: Unstable fusing temperature During standby, within 500 ms, the fusing temperature goes below 60 °C twice or over 60 °C three times. Within 1 minute, a 60 °C increase or decrease in fusing temperature is detected during five different onesecond intervals.
Causes: • Fusing thermistor defective • Power supply board defective • Poor connection of the fusing unit

Code: 547

Description: Zero cross signal malfunction Zero cross signals are not detected within 5 seconds.
Causes: • Power supply board defective • Poor mains power supply condition

Code: 610

Description: Communication error - duplex unit The engine board cannot communicate with the duplex unit.
Causes: • Poor connection between engine board and duplex unit • Engine board defective • Duplex control board defective

Code: 640

Description: Engine to controller communication error.
Causes: • Check the connection between the controller and the engine board. • Replace the engine board if the error is frequent. • Replace the controller if the error is frequent.

Code: 641

Description: Engine to controller communication error (no answer).
Causes: • Check the connection between the controller and the engine board. • Replace the engine board if the error is frequent.
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie