• Code: 737
• Description: Trimmed staple waste hopper full
  The hopper that holds the waste from staple trimming is full.
• Causes: • Staple waste hopper full
  • Staple waste sensor defective

• Code: 738
• Description: Finisher pressure plate motor error
  The pressure plate motor switches on but does not return to the home position within the prescribed time after 2 counts
• Causes: • HP sensor defective
  • Harness disconnected, defective
  • Motor defective
  • Finisher main board defective
  • Motor overload

• Code: 739
• Description: Finisher folder plate motor error
  The folder plate motor turns on but the plate does not return to the home position within the prescribed time for 2 counts
• Causes: • Plate HP sensor defective
  • Harness disconnected, defective
  • Folder plate motor defective
  • Finisher main board defective
  • Folder plate motor overload

• Code: 740
• Description: Finisher front saddle-stitch stapler motor error B140
  Saddle-stitch stapler motor fails to operate within 450 ms within 2 counts..
• Causes: • HP sensor defective
  • Harness disconnected, defective
  • Stapler motor defective
  • Finisher main board defective
  • Stapler motor overload

• Code: 740
• Description: Finisher corner stapler motor error B246
  The stapler motor does not switch off within the prescribed time after operating. The 1st detection failure issues a jam error, and the 2nd failure issues this SC code.
• Causes: • Staple jam
  • Number of sheets in the stack exceeds the limit for stapling
  • Stapler motor disconnected, defective

• Code: 741
• Description: Finisher rear saddle-stitch stapler motor error B140
  Saddle-stitch stapler motor fails to operate within 450 ms within 2 counts..
• Causes: • HP sensor defective
  • Harness disconnected, defective
  • Stapler motor defective
  • Finisher main board defective
  • Stapler motor overload

• Code: 741
• Description: Finisher corner stapler rotation motor error B246
  The stapler does not return to its home position within the specified time after stapling. The 1st detection failure issues a jam error, and the 2nd failure issues this SC code.
• Causes: • Stapler rotation motor disconnected, defective
  • Stapler rotation motor overloaded due to obstruction
  • Stapler rotation HP sensor disconnected, defective

• Code: 742
• Description: Finisher jogger side fence motor error B140
  The jogger motor turns on but the side fences to not return to the home position within 340 pulses for 2 counts.
• Causes: • HP sensors defective
  • Harness disconnected, defective
  • Motor defective
  • Finisher main board defective
  • Motor overload