• Code: 762
• Description: ARDF gate abnormal 3
  The FGATE signal is not terminated by the ARDF within 60 seconds after the ARDF starts feeding.
• Causes: • ARDF connector defective • SBU board defective

• Code: 792
• Description: Finisher error
  The machine does not recognize the finisher, but recognizes the bridge unit.
• Causes: • Defective connector • Defective harness • Incorrect installation

• Code: 793
• Description: Front jogger motor error
  • The machine does not detect that the front jogger HP sensor is OFF for 40 ms after the front jogger fence moved. • The machine does not detect that the front jogger fence HP sensor is ON for 830 ms after the front jogger fence returned to its home position.
• Causes: • Defective front jogger motor • Disconnected connector • Overload to front jogger motor • Defective front jogger fence HP sensor

• Code: 794
• Description: Rear jogger motor error
  • The machine does not detect that the rear jogger HP sensor is OFF for 40 ms after the rear jogger fence moved. • The machine does not detect that the rear jogger fence HP sensor is ON for 830 ms after the rear jogger fence returned to its home position.
• Causes: • Defective rear jogger motor • Disconnected connector • Overload to rear jogger motor • Defective rear jogger fence HP sensor

• Code: 795
• Description: Pick-up roller HP sensor error
  • The pick-up roller HP sensor does not turn off for 650 msec after the pick-up roller has lifted down. • The pick-up roller HP sensor does not turn on for 650 msec after the pick-up roller has lifted up.
• Causes: • Disconnected harness • Defective pick-up roller contact motor • Defective pick-up roller HP sensor

• Code: 796
• Description: Transport belt solenoid error
  The 1st detection failure issues a jam error, and the 2nd failure issues this SC code. • The machine does not detect that the belt lift sensor is ON at initializing after the paper transport motor has rotated.
• Causes: • Disconnected harness • Defective paper transport motor • Belt lift sensor defective

• Code: 797
• Description: EEPROM data error
  The job data is not transferred to the EEPROM.
• Causes: • Defective EEPROM on the control board

• Code: 901
• Description: Mechanical total counter
  The mechanical total counter does not work properly.
• Causes: • Mechanical total counter defective • BICU defective • Disconnected mechanical total counter