Description: Exposure lamp error
The standard white level was not detected properly when scanning the white plate.
Causes: • Exposure lamp defective • Lamp stabilizer defective • Exposure lamp connector defective • Standard white plate dirty • Scanner mirror or scanner lens out of position or dirty • SBU defective
Description: Scanner home position error 1
The scanner home position sensor does not detect the on condition during initialization or copying.
Causes: • SIB or scanner drive motor defective • Scanner motor defective • Harness between SIB and scanner drive motor disconnected • Harness between SIB and scanner drive motor power source disconnected • Scanner HP sensor defective • Harness between SIB and HP sensor disconnected • Scanner wire, timing belt, pulley, or carriage defective
Description: Scanner home position error 2
The scanner home position sensor does not detect the off condition during initialization or copying.
Causes: • SIB or scanner motor drive board defective • Scanner motor defective • Harness between SIB and scanner drive motor disconnected • Harness between SIB and scanner drive motor power source disconnected • Scanner HP sensor defective • Harness between SIB and scanner HP sensor disconnected • Scanner wire, timing belt, pulley, or carriage defective
Description: SBU auto adjust error
One of the following occurred: When the machine was powered on, automatic adjustment of the SBU failed. Automatic white density adjustment failed when reading standard white plate
Causes: • Exposure lamp defective • Lamp stabilizer defective • Lamp stabilizer connection loose, disconnected or damaged • White plate mounting is incorrect or defective • Scanner mirror or scanner lens out of position or dirty • SBU defective • BICU (Ri10) defective • SIB defective • Harness connections between SIB and SBU loose, disconnected, or damaged.
Description: SBU communication error
Immediately after power on, the operation check done by the SIB for the SBU failed because the SBU was not operating normally.
Causes: • Flat film or harness connectors between the SBU and SIB are loose, disconnected, or damaged • Replace SBU • Replace BICU
Description: Copy Data Security Unit error
An error occurred when the machine attempted to set the Copy Data Security Unit SD card.
Causes: • The Copy Data Security Unit card not installed • The Copy Data Security Unit card is installed, but it is not the correct type for the machine.
Description: Charge roller current correction error
The charge roller bias correction is performed twice even if the maximum charge roller bias (-2000V) is applied to the roller.
Causes: • ID sensor defective
Nhận ưu đãi sớm nhất khi chương trình diễn ra
Đăng ký nhận bản tin
Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này.
Chính sách cookie
Những cookie này là cần thiết để trang web hoạt động đúng cách.
Những cookie này giúp chúng tôi hiểu cách khách truy cập tương tác với trang web.
Những cookie này được sử dụng để cung cấp quảng cáo cá nhân hóa.