Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi Ricoh Aficio MP4000B

Code: 101

Description: Exposure lamp error
-001: Shading at AGC
-002: Shading at scanning
• The standard white level was not detected properly when scanning the white plate
Causes: • Exposure lamp defective • Lamp stabilizer defective • Exposure lamp connector defective • Standard white plate dirty • Scanner mirror or scanner lens out of position or dirty • SBU defective

Code: 120

Description: Scanner home position error 1
The scanner home position sensor does not detect the “OFF” condition during initialization or copying.
Causes: SIB or scanner drive motor defective • Scanner motor defective • Harness between SIB and scanner drive motor disconnected • Harness between SIB and scanner drive motor power source disconnected • Scanner HP sensor defective • Harness between SIB and HP sensor disconnected • Scanner wire, timing belt, pulley, or carriage defective

Code: 121

Description: Scanner home position error 2
The scanner home position sensor does not detect the “ON” condition during initialization or copying.
Causes: • SIB or scanner motor drive board defective • Scanner motor defective • Harness between SIB and scanner drive motor disconnected • Harness between SIB and scanner drive motor power source disconnected • Scanner HP sensor defective • Harness between SIB and scanner HP sensor disconnected • Scanner wire, timing belt, pulley, or carriage defective

Code: 141

Description: Black level detection error
The black level cannot be adjusted within the target value during the zero clamp.
Causes: • Defective SBU

Code: 142

Description: White level detection error
The white level cannot be adjusted within the target during auto gain control.
Causes: • Dirty exposure glass or optics section • SBU board defective • Exposure lamp defective • Lamp stabilizer defective

Code: 143

Description: SBU auto adjust error
One of the following occurred:
• When the machine was powered on, automatic adjustment of the SBU failed.
• Automatic white density adjustment failed when reading standard white plate.
Causes: • Exposure lamp defective • Lamp stabilizer defective • Lamp stabilizer connection loose, disconnected or damaged • White plate mounting is incorrect or defective • Scanner mirror or scanner lens out of position or dirty • SBU, SCNB defective • BICU (Ri10) defective • Harness connections

Code: 144-001

Description: SBU connection error
The SBU connection cannot be detected at power on or recovery from the energy save mode.
Causes: • Defective SBU • Defective harness • Defective detection port on the BICU

Code: 144-002

Description: SBU serial communication error
The power ON of the SBU is not detected.
Causes: • Defective SIO, SBU or SCNB • Defective harness • Defective detection port on the BICU
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie