Description: FGATE OFF error The FGATE signal does not assert within the prescribed time. (The BICU generates the FGATE signal and sends it to the LD unit when the registration sensor switches on.)
Description: X The I2C bus device ID is not identified during initialization. X A device-status error occurs during I2C bus communication. X The I2C bus communication is not established due to an error other than a buffer shortage
Description: Charge roller bias correction leak The charge roller bias correction is performed twice even if the maximum charge roller bias (-2000V) is applied to the roller.
Description: Development roller bias leak The maximum PMW duty (65%) is detected for 60 ms after the high voltage has been supplied to the development unit.
Causes: • Development bias leak • Broken harness • Defective high voltage power supply, voltage supply • Defective high voltage supply unit
Description: Development paddle motor error The machine detects a lock signal error from the development puddle motor for 2 seconds after the drum motor has turned on.
Causes: • Overload on the development puddle motor • Defective development puddle motor • Defective harness • Defective IOB
Description: ID sensor pattern test error One of the following readings occurred 10 times in the ID sensor output when the ID sensor pattern was checked: 1) Vsp < 2.5V 2) Vsg > 2.5V 3) Vsp = 0V 4) Vsg = 0V
Causes: • ID sensor connector defective • Poor ID sensor connector connection • I/O board (IOB) defective • Poor writing of ID sensor pattern on the drum • High voltage supply board defective
Nhận ưu đãi sớm nhất khi chương trình diễn ra
Đăng ký nhận bản tin
Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này.
Chính sách cookie
Những cookie này là cần thiết để trang web hoạt động đúng cách.
Những cookie này giúp chúng tôi hiểu cách khách truy cập tương tác với trang web.
Những cookie này được sử dụng để cung cấp quảng cáo cá nhân hóa.