Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi Ricoh Aficio MP401SPF — Trang 2/35

Code: SC165

Description: Unauthorized copy protection failed
Causes: • The machine detects that the optional ICIB is not installed or is faulty even if "Unauthorized Copy Protection" in User Tools is enabled. • When the machine is switched on or recovers from the evergy saver mode, it detects that the installed optional ICIB is faulty. • ICIB nlot attached correctly • Defective ICIB
Remedy: • Connect the ICIB correctly • Replace the ICIB

Code: SC195

Description: Machine serial number error
Causes: Comparison of the product identification code in the machine serial number (11 digits). The product identification code in the machine serial number (11 digits) does not match.
Remedy: Re-enter the machine serial number.

Code: SC230-00

Description: FGATE*1 : Does not turn ON. (*1)FGATE: Signals used between the controller and the engine in order to send the information about the sub scan length of the page to be printed.
Causes: GPIO*2 has not been asserted, although the specified time (200 ms) elapsed after setting JOB to be started and reaching the FGAT assert time. Control Board (*2)GPIO: A type of input/output terminal
Remedy: Turn the main power OFF and then ON.

Code: SC231-00

Description: FGATE*1: Does not turn OFF. (*1)FGATE: Signals used between the controller and the engine in order to send the information about the sub scan length of the page to be printed.
Causes: GPIO*2 has not been negated, although the specified time (200 ms) elapsed after detecting GPIO*assert and then reaching the expected FGATE negate time. * This is an I/O pin. Such I/O pins can be used for a variety of applications, depending on the setting. (*2)GPIO: A type of input/output terminal
Remedy: • Control Board • Engine Board

Code: SC270-00

Description: Write ASIC communication error
Causes: • When the Engine Board could not read the Unique ID of the Writing ASIC properly when starting this machine. • When an Error bit occurred in the communication between the Engine Board and the Writing ASIC. The unique ID of the write ASIC was not read normally.
Remedy: • Turn the main power OFF and then ON. • Engine Board

Code: SC277-00

Description: LEDA communication error
Causes: The head type data was read three times in succession. • Defective ASIC • Defective LEDA
Remedy: • Turn the main power OFF and then ON. • Replace the LED head

Code: SC277-10

Description: LEDA communication error
Causes: The head type data was read three times in succession. • LEDA power source error
Remedy: • Turn the main power OFF and then ON. • Replace the LED head

Code: SC302

Description: High voltage output error: Charge unit /Development unit
Causes: This SC is issued if the BICU detects a short in the power pack 10 times consecutively. Open circuit (+) / Short circuit (-)
Remedy: • Turn the main power OFF and then ON. • Replace the controller board. • Check the connector connection.
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie