Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi Ricoh Aficio MP4054 — Trang 32/40

Code: SC835-00

Description: Self-diagnostic error: Centronic device [xxxx]: Detailed error code
Causes: [1102] Verify error The loopback connector is connected but check results is an error. • IEEE1284 connector error • Centronic loopback connector defective Replace the controller board. [110C] DMA verify error The loopback connector is connected but check results is an error. • ASIC device error • IEEE1284 connector error • Centronic loopback connector is defective Replace the controller board. [1120] Loopback connector undetected Centronic loopback connector is not connected for detailed selfdiagnostic test. • Centronic loopback connector not connected correctly • Centronic loopback connector is defective • ASIC device is defective • Connect the centronic loopback connector • Replace the centronic loopback connector • Replace the controller board.
Remedy:

Code: SC838-00

Description: Self-diagnostic Error: Clock Generator [xxxx]: Detailed error code
Causes: [2701] Verify error A verify error occurred when setting data was read from the clock generator via the I2C bus. • Defective clock generator • Defective I2C bus • Defective I2C port on the CPU
Remedy: Replace the controller board.

Code: SC839-00

Description: Self-diagnostic Error: Serial Flash [xxxx]: Detailed error code
Causes: [9001] Serial Flash access error USB NAND Flash ROM cannot be read. Defective controller board
Remedy: Replace the controller board.

Code: SC840-00

Description: EEPROM access error
Causes: • During the I/O processing, a reading error occurred. The 3rd reading failure causes this SC code. • During the I/O processing, a writing error occurred.
Remedy: • Defective EEPROM

Code: SC841-00

Description: EEPROM read data error. Mirrored data of the EEPROM is different from the original data in EEPROM.
Causes: Data in the EEPROM is overwritten for some reason.
Remedy:

Code: SC842-01

Description: Insufficient Nand-Flash blocks (threshold exceeded) At startup, or when machine returned from low power mode, the Nand- Flash status was read and judged that the number of unusable blocks had exceeded threshold, and then SCS generated the SC code.
Causes: Number of unusable blocks exceeded threshold for Nand-Flash
Remedy: Replace the controller board.

Code: SC842-02

Description: Number of Nand-Flash block deletions exceeded At startup, or when the machined returned from low power mode, the Nand-Flash was read and judged that the number of deleted blocks had exceeded threshold, and then SCS generated this SC code.
Causes: Number of blocks deleted exceeded threshold for Nand-Flash
Remedy: Replace the controller board.

Code: SC853-00

Description: Bluetooth device connection error The Bluetooth hardware (USB type) was connected after the machine was turned on.
Causes: The Bluetooth hardware (USB type) was connected after the machine was turned on.
Remedy: Always connect the Bluetooth device (USB type) before the machine is turned on.
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie