Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi Ricoh Aficio MP5000 — Trang 4/21

Code: 320

Description: Development roller bias leak
The maximum PMW duty (65%) is detected for 60 ms after the high voltage has been supplied to the development unit.
Causes: • Development bias leak • Broken harness • Defective high voltage power supply, voltage supply • Defective high voltage supply unit

Code: 324

Description: Development paddle motor errorThe machine detects a lock signal error from the development puddle motor for 2 seconds after the drum motor has turned on.
Causes: • Overload on the development puddle motor • Defective development puddle motor • Defective harness • Defective IOB

Code: 350

Description: ID sensor pattern test error
One of the following readings occurred 10 times in the ID sensor output when the ID sensor pattern was checked:
1) Vsp > 2.5V
2) Vsg < 2.5V
3) Vsp =0V
4) Vsg = 0V
Causes: • ID sensor connector defective • Poor ID sensor connector connection • I/O board (IOB) defective • Poor writing of ID sensor pattern on the drum • High voltage supply board defective

Code: 351

Description: ID sensor Vsg test error
When the ID sensor was checked, the ID sensor output voltage is 5.0V while the LED current value is 0.
Causes: • ID sensor defective or dirty • ID sensor connector defective • Poor ID sensor connection • I/O board (IOB) defective • Scanning system defective • High voltage supply board defective • Defect at the ID sensor pattern writing area of the drum

Code: 355

Description: Grayscale measurement error
When the grayscale control result is the maximum and it does not operate correctly and these cases are detected 15 times.
Causes: • ID sensor defective or dirty • The life of ID sensor or photo conductor • Shield glass dirty

Code: 360

Description: TD sensor (Vt) error 1
The following condition occurs thirty times consecutively during printing. Vt is less than 0.5V or 4.8V or more
Causes: • TD sensor disconnected • Harness between TD sensor and PCDU defective • Defective TD sensor.

Code: 372

Description: TD sensor adjustment error
Vts is less than 1.8V or 4.8V or more during TD sensor initialization.
Causes: • Heat seal not removed from a new developer pack • TD harness sensor disconnected, loose or defective • TD sensor defective • Harness between TD sensor and drawer disconnected, defective

Code: 396

Description: Drum motor error
The machine detects a lock signal error from the drum motor for 2 seconds after the drum motor turned on.
Causes: • Overload on the motor • Defective drum motor • Defective harness • Defective IOB
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie