Description: NRS Modem Communication Error
One of the following factors could be the cause of this error:
• In the User Tools, check the settings for the dial-up user name and dial up password.
• Modem has been disconnected.
• Modem board disconnected
Causes: Check the following for a machine that is using Cumin (NRS modem):
• An error was returned during the dialup connection
• A network was detected at startup
• At startup the machine detected that the NIB was disabled, or did not detect a modem board
Description: Engine startup error
The machine engine, controlled by the BICU (Base Image Control Unit), was operating incorrectly when the machine was switched on or returned to normal operation from the energy save mode.
Causes: • Check the connections between BICU and controller
• BICU defective
• Controller board defective
• PSU defective
Description: Controller startup error
• After power on, the line between the controller and the operation panel did not open for normal operation.
• After normal startup, communication with the controller stopped.
Description: ADF bottom plate motor error
• Bottom plate position sensor does not detect the plate after the bottom plate lift motor switches on to lift the plate.
• Bottom plate HP sensor does not detect the plate after the bottom plate motor reverses to lower the plate.
Causes: • Bottom plate position sensor defective
• Bottom plate HP sensor defective
• Bottom plate motor defective
• ADF main board defective
Description: Finisher transport motor error
The encoder pulse of the finisher transport motor does not change state (high/low) within 600 ms and does not change after 2 retries.
Causes: • Finisher transport motor defective
• Transport motor harness disconnected, or defective
• Finisher main board defective
Description: Finisher jogger motor error
• The finisher jogger HP sensor remains de-activated for more 1,000 pulses when returning to home position.
• The finisher jogger HP sensor remains activated for more than 1,000 pulses when moving away from home position
Causes: • Jogger HP sensor defective
• Jogger mechanism overload
• Jogger motor defective (not rotating)
• Finisher main board defective
• Harness disconnected or defective
Nhận ưu đãi sớm nhất khi chương trình diễn ra
Đăng ký nhận bản tin
Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này.
Chính sách cookie
Những cookie này là cần thiết để trang web hoạt động đúng cách.
Những cookie này giúp chúng tôi hiểu cách khách truy cập tương tác với trang web.
Những cookie này được sử dụng để cung cấp quảng cáo cá nhân hóa.