Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi Ricoh Aficio MP7500 — Trang 9/25

Code: 542

Description: Fusing temperature warm-up error
One of the following occurred:
• After power on, or after closing the front door, the hot roller does not reach the 100°C control temperature within 25 s.
• 5 sec. after temperature rise started, temperature remained below 21°C after 5 samplings.
• Fusing unit did not attain reload temperature within 48 sec. of the start of fusing temperature control.
Causes: • Fusing lamp disconnected
• Thermistor warped, out of position
• Thermostat not operating

Code: 543

Description: Fusing lamp overheat error 1 (software)
Central thermistor detected a temperature of 240°C at the center of the hot roller. Fusing temperature control software error
Causes: • PSU defective
• IOB defective
• BICU defective

Code: 544

Description: Fusing lamp overheat error 1 (hardware)
The central thermistor or an end thermistor detected a temperature of 250°C on the hot roller.
Causes: • PSU defective
• IOB defective
• BICU defective

Code: 545

Description: Fusing lamp overheat error 2
After hot roller reaches warmup temperature, the fusing lamps remained on at full capacity for 11 samplings (1.8 sec. duration) while the hot roller was not rotating.
Causes: • Thermistor damaged, or out of position
• Fusing lamp disconnected

Code: 547

Description: Zero cross signal malfunction
One of the following conditions is detected 10 times:
• When the main switch is on, the frequency measured by the number of zero cross signals for 500 ms is larger than 66Hz or smaller than 45 Hz.
• The interval between one zero cross signal and the next is 7.5 ms or shorter 3 times consecutively for 500 ms.
Causes: • Noise on the ac power line

Code: 550

Description: Fusing Web End
Web end detected 5 times within 500 ms and web motor continues to rotate 40 s. If web end is detected for another 500 ms, then the SC is logged.
Causes: • Web end (requires replacement)
• Web end sensor defective Note: After replacing the web with a new one, reset SP1902 001 to "0" to release SC550.

Code: 551

Description: Fusing thermistor error 1
The end thermistor (contact type) was less than 0C (32F) for more than 7 seconds.
Causes: • Thermistor disconnected
• Thermistor connector defective

Code: 552

Description: Fusing thermistor error 2
The end thermistor (contact type) could not detect:
• 100°C 25 seconds after the start of the warmup cycle.
• A change in temperature more than than 16 degrees for 5 seconds.
• The reload temperature with 56 seconds after the start of the fusing temperature control cycle.
Causes: • Fusing lamp disconnected
• Thermistor bent, damaged
• Thermistor position incorrect
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie