Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi Ricoh Aficio MP7500SP — Trang 6/25

Code: 352

Description: ID sensor error 3
For 2 s during the ID sensor pattern check, the ID sensor pattern edge voltage is not 2.5V or the pattern edge is not detected within 800 ms.
Causes: • ID sensor defective
• ID sensor harness disconnected
• ID sensor connector defective
• IOB defective
• ID sensor pattern not written correctly
• Incorrect image density
• Charge power pack defective
• ID sensor dirty

Code: 353

Description: ID sensor error 4
One of the following ID sensor output voltages is detected at ID sensor initialization. . Vsg < 4.0V when the maximum PWM input (255) is applied to the ID sensor. . Vsg . 4.0V when the minimum PWM input (0) is applied to the ID sensor.
Causes: • ID sensor defective
• ID sensor harness disconnected
• ID sensor connector defective
• IOB defective
• ID sensor pattern not written correctly
• Incorrect image density
• Charge power pack defective
• ID sensor dirty

Code: 354

Description: ID sensor error 5
Vsg falls out of the adjustment target (4.0 ± 0.2V) during Vsg checking
Causes: • ID sensor defective
• ID sensor harness disconnected
• ID sensor connector defective
• IOB defective
• ID sensor pattern not written correctly
• Incorrect image density
• Charge power pack defective
• ID sensor dirty

Code: 355

Description: ID sensor error 6
The Vp value, which measures the reflectivity of the ID sensor pattern, was not in the range of –70V to –400V.
Causes: • Potential sensor defective
• Potential sensor harness defective
• Potential sensor disconnected
• IOB defective
• OPC unit connector defective
• Charge corona power pack defective
• Charge corona wire dirty, broken

Code: 401

Description: Transfer output abnormal
When the transfer is output, the feedback voltage remains higher than 4V for 60 ms.
Causes: • Transfer power pack defective
• Transfer current terminal, transfer power pack disconnected, damaged connector

Code: 402

Description: Transfer output abnormal release detection
When the transfer is output, there is hardly any feedback voltage within 60 ms even with application of 24% PWM.
Causes: • Transfer power pack defective
• Transfer unit harness disconnected
• Transfer connector loose, defective

Code: 430

Description: Quenching lamp error
At the completion of auto process control initialization, the potential of the drum surface detected by the potential sensor is more than –400V, the prescribed value.
Causes: • Quenching lamp defective
• Quenching lamp harness disconnected
• Quenching lamp connector loose,
defective

Code: 440

Description: Main motor lock
The main motor lock signal remains low for 2 seconds while the main motor is on.
Causes: • Drive mechanism overloaded
• Motor driver board defective
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie