• Code: 793
• Description: Front jogger motor error with side tray (D038/D041)
  The machine does not detect a correct signal from the front jogger fence HP sensor at power-on. The 1st detection failure issues a jam error, and the 2nd failure issues this SC code.
• Causes: • Defective front jogger motor • Loosen connection • Motor overload • Defective front jogger fence HP sensor
• Remedy: 1. Replace the front jogger fence HP sensor. 2. Replace the front jogger motor.

• Code: 794
• Description: Rear jogger motor error with side tray (D038/D041)
  The machine does not detect a correct signal from the rear jogger fence HP sensor at power-on. The 1st detection failure issues a jam error, and the 2nd failure issues this SC code.
• Causes: • Defective rear jogger motor • Loosen connection • Motor overload • Defective rear jogger fence HP sensor
• Remedy: 1. Replace the rear jogger fence HP sensor. 2. Replace the rear jogger motor.

• Code: 795
• Description: Pick-up roller contact motor error with side tray (D038/D041)
  The machine does not detect a correct signal from the pick-up roller HP sensor at power-on. The 1st detection failure issues a jam error, and the 2nd failure issues this SC code.
• Causes: • Defective pick-up roller contact motor • Loosen connection • Motor overload • Defective pick-up roller HP sensor
• Remedy: 1. Replace the pick-up contact motor. 2. Replace the pick-up roller HP sensor.

• Code: 796
• Description: Belt roller solenoid error
• Causes: • Disconnected harness • Defective belt roller position sensor • Defective belt roller solenoid
• Remedy: 1. Check the harness connection. 2. Replace the belt roller position sensor. 3. Replace the belt roller solenoid.

• Code: 797
• Description: NVRAM data error
• Causes: • Defective NVRAM on the main board of the internal finisher
• Remedy: 1. Check the harness connection. 2. Replace the main board.

• Code: 798
• Description: Front Fan error
  The machine detects the fan lock signal (ON) consecutively 200 ms.
• Causes: • Front fan damaged • Disconnect or defective the harness • Front fan overload
• Remedy: 1. Check or replace the harness. 2. Replace the front fan.

• Code: 799
• Description: Output tray motor error
• Causes: • Output tray motor damaged • Output tray motor overload • Loose connection of the output tray motor • Defective output tray motor
• Remedy: Replace the output tray unit.

• Code: 816
• Description: Energy saving I/O sub-system error
  The energy saving I/O sub-system detects an error.
• Causes: • Controller board defective
• Remedy: Replace the controller board.