• Code: 766
• Description: Paper position sensor slide motor error
  The paper position sensor moves but is not detected at the home position within the specified time. The 1st detection failure issues a jam error, and the 2nd failure issues this SC code.
• Causes: • Motor harness disconnected, loose, defective • Defective motor
• Remedy: 1. Check the connections to the paper position sensor slide motor. 2. Defective paper position sensor slide motor.

• Code: 770
• Description: Shift motor error
  The shift motor HP sensor does not detect any change for 1.86 seconds after the shift motor has turned on at power on or during its operation.
• Causes: • Defective shift motor • Defective shift motor HP sensor
• Remedy: 1. Check the connections to the shift motor and the shift motor HP sensor. 2. Defective shift motor or the shift motor HP sensor.

• Code: 791
• Description: Bridge unit error
  The machine recognizes the finisher, but does not recognize the bridge unit.
• Causes: • Defective connector • Broken harness
• Remedy: 1. Check the connections between the bridge unit and the machine. 2. Install a new bridge unit.

• Code: 792
• Description: Finisher error
  The machine does not recognize the finisher, but recognizes the bridge unit.
• Causes: • Defective connector • Defective harness • Incorrect installation
• Remedy: 1. Check the connections between the finisher and the machine. 2. Install a new finisher.

• Code: 798-1
• Description: Upper limit switch error
  The upper limit switch is pushed due to tray lift error or some problems.
• Causes: • Upper limit switch pulled up • Defective upper limit swtich
• Remedy: Check the harness. 1. Check for blockage around the upper limit switch. 2. Replace the upper limit switch.

• Code: 798-2
• Description: Finisher jogger motor error
  The jogger fences move out of the home position but the HP sensor output does not change within the specified number of pulses. The 1st failure issues an original jam message, and the 2nd failure issues this SC code.
• Causes: • Jogger HP sensor disconnected, defective • Jogger motor disconnected, defective • Jogger motor overloaded due to obstruction • Finisher main board and jogger motor
• Remedy: 1. Check or replace the harness. 2. Check for blockages in the jogger motor mechanism. 3. Replace the jogger HP sensor. 4. Replace the jogger motor. 5. Replace the finisher main board.

• Code: 798-3
• Description: Rear fence motor error
  The rear jogger fence motor in the finisher is not operating.
• Causes: • Rear jogger motor drive is obstructed (jammed paper, paper scraps, etc.) • The rear jogger fence motor harness loose or broken • Rear jogger fence HP sensor dirty, loose, defective • Rear jogger fence motor defective
• Remedy: 1. Check or replace the harness. 2. Check for blockages in the rear jogger motor drive mechanism. 3. Replace the rear jogger fence HP sensor. 4. Replace the rear jogger fence motor.

• Code: 798-4
• Description: Stack feed-out motor error
  The stack feed-out HP sensor does not detect the home position of the stack feedout belt for a certain time after the stack feed-out belt has moved to its home position. The stack feed-out HP sensor does not turn off for a certain time after the stack feedout belt has moved from its home position. The 1st detection failure causes a jam error, and the 2nd failure causes this SC code.
• Causes: • Defective stack feed-out HP sensor • Overload on the stack feed-out motor • Defective stack feed-out motor • Defective main board • Disconnected or defective harness
• Remedy: 1. Check or replace the harness. 2. Check for blockages in the stack feed-out mechanism. 3. Replace the stack feed-out HP sensor. 4. Replace the stack feed-out motor. 5. Replace the main board.