Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi Ricoh Aficio MPC3003SP — Trang 15/45

Code: SC534-03

Description: Ozone Exhaust Fan Lock In the motor ON state, the value of the lock sensor is checked every 100msec. If a lock signal is not obtained for 50 times consecutively.
Causes: • Motor defective • Connector disconnected • Harness broken • IOB defective
Remedy: • Replace the motor • Reset the connector • Replace the harness • Replace the IOB • Replace the fan

Code: SC535-00

Description: Paper Exit Cooling Fan Lock In the motor ON state, the value of the lock sensor is checked every 100msec. If a lock signal is not obtained for 50 times consecutively.
Causes: • Motor defective • Connector disconnected • Harness broken • IOB defective
Remedy: • Replace the motor • Reset the connector • Replace the harness • Replace the IOB • Replace the fan

Code: SC540-00

Description: Fusing Motor: Lock During motor ON, after checking lock signals for 2sec, a High level was detected at least 20 times.
Causes: • Motor defective • Connector disconnected • Harness broken • IOB defective • Unit torque increased
Remedy: • Replace the motor • Reset the connector • Replace the harness • Replace the IOB • Replace the unit

Code: SC541-01

Description: Fusing Central Thermopile Disconnection Below -50 degrees C (or below CB) is detected for (t11) seconds continuously.
Causes: • disconnection • Connector disconnected
Remedy: • Replace the thermopile • Reset the connector • Replace the connector • Replace the unit

Code: SC541-02

Description: Central NC Sensor Disconnection 3ED - 3FF (FB voltage: 3.243V-3.300V) is detected for (t13) seconds continuously (NC sensor center: detection & compensation NC sensor edge: detection & compensation). Detection period: 100 ms, detection frequency: 10 times or more.
Causes: • NC sensor disconnection • Connector disconnected
Remedy: • Reset the NC sensor • Reset the connector • Replace the connector • Replace the unit

Code: SC541-03

Description: Central NC sensor short-circuit AD value: 0-13 (FB voltage: 0.000V-0.041V) (*3) is detected for (t14) seconds continuously. Detection period: 100 ms, detection frequency: 10 times or more.
Causes: • NC short-circuit • Connector disconnected
Remedy: • Reset the NC sensor • Reset the connector • Replace the connector • Replace the unit

Code: SC542-02

Description: Fusing central thermopile does not reload (T21) degrees C not reached after heater 1 ON for (t3) seconds
Causes: • Thermopile lens dirt • Thermopile modification/float • Outside input voltage guarantee • After excessive temperature rise prevention unit operation
Remedy: • Replace the thermopile • Check that the input voltage is within acceptable limits • Replace the unit

Code: SC542-03

Description: Fusing central thermopile does not reload Heating central reload permission temperature not reached after heater 1 ON for (t311) seconds.
Causes: • Thermopile lens dirt • Thermopile modification/float • Outside input voltage guarantee • After excessive temperature rise prevention unit operation
Remedy: • Replace the thermopile • Check that the input voltage is within acceptable limits • Replace the unit
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie