Description: Positioning roller arm motor error The positioning roller HP sensor does not turn on or off for a certain time at poweron. The positioning roller HP sensor does not turn on or off for a certain time when the positioning roller returns to its home position from the lower position. The 1st detection failure causes a jam error, and the 2nd failure causes this SC code.
Causes: • Disconnected or defective harness • Overload on the positioning roller arm motor • Defective positioning roller arm motor • Defective positioning roller HP sensor
Remedy: 1. Check or replace the harness. 2. Check for blockages in the positioning roller arm mechanism. 3. Replace the positioning roller arm motor. 4. Replace the positioning roller HP sensor.
Description: Finisher corner stapler motor error The 1st detection failure issues a jam error, and the 2nd failure issues this SC code. For 500-sheet finisher • The stapler HP sensor does not detect "ON"/"OFF" signal even the stapler moves from the "OFF"/"ON" position for 0.6 seconds. • The stapler HP sensor does not detect "ON" when a stapling job is commanded or the stapler moves.
Causes: • Staple jam • Motor overload • Defective stapler motor
Remedy: 1. Check the connections and cables for the components mentioned above. 2. Replace the HP sensor and/or stapler motor 3. Replace the finisher main board.
Description: Finisher stapler movement motor error For 500-sheet finisher • The stapler HP sensor does not detect "OFF" signal even the stapler moves from the "ON" position for 0.35 seconds. • The stapler HP sensor does not detect "ON" signal even the stapler moves from the "OFF" position for 5.5 seconds.
Causes: • Motor overload • Loose connection of the stapler home position sensor • Loose connection of the stapler movement motor • Defective stapler home position sensor • Defective stapler movement motor
Remedy: 1. Check the connection of the stapler movement motor. 2. Check the connection of the stapler home position sensor. 3. Replace the stapler home position sensor. 4. Replace the stapler movement motor.
Description: Fatal kernel erro Due to a control error, a RAM overflow occurred during system processing. One of the following messages was displayed on the operation panel.
Causes: [0x5032] HAIC-P2 error [0x5245] vm_pageout: VM is full [0x5355] L2 status time out [554C] USB error • System program defective • Controller board defective • Optional board defective